User manual SANYO POA-RCKIT03

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures : ­ Reorient or relocate the receiving antenna. ­ Increase the separation between the equipment and receiver. [. . . ] Refer to the Owner's Manual of your projector for switching the code of the projector. SAFETY PRECAUTIONS Before operation, read this Instruction Manual thoroughly to operate properly. This Remote Control Unit emits laser beam from the Laser Light Window while pressing the LASER button (for 1 minute / The Signal Emission Indicator lights red to indicate the laser emission). Do not look into the Laser Light Window or shine laser beam on yourself or the other people. If this Remote Control Unit is not to be used for an extended time, remove batteries. Do not apply benzene, thinner, splay or any chemical materials. DO NOT OPEN AND ATTEMPT TO SERVICE INSIDE OF THE REMOTE CONTROL UNIT. THERE ARE NO SERVICEABLE PARTS. 2 NAME AND FUNCTION OF EACH BUTTON SIGNAL EMISSION INDICATOR POWER ON-OFF button Turn the projector on or off. COMPUTER button Select the input source (COMPUTER). VIDEO button Select the (VIDEO). input source AUTO PC button D. ZOOM buttons Select the Digital zoom +/­ mode and resize the image. Operate the Auto PC adjustment function. KEYSTONE button Correct keystone distortion. SELECT button Execute the item selected, or expand or compress the image in the Digital zoom +/mode. POINT (VOLUME+/-) buttons Select an item or adjust the value in the On-Screen Menu. These are also used to pan the image in the Digital zoom +/mode. The POINT 7 8 buttons are also used as the VOLUME +/- buttons. MENU button Open or close the On-Screen Menu. LASER button Operate the Laser pointer function. The Laser beam is emitted while pressing this button within 1 minute. When using this laser pointer for more than 1 minute, release the LASER button and press it again. FREEZE button Freeze the projected picture. PAGE buttons Turn page; the Up button to the previous page and the Down button to the next page for an image from a computer. Connect the projector and your computer with a USB cable before use. IMAGE button Select image levels. P-TIMER button Operate the P-Timer function. NO SHOW button Turn the picture into black image. MUTE button Mute the sound. Note : For detailed operation, refer to the projector owner's manual. 3 English Light red while the laser beam is emitted from the Laser Light Window or the signal is being sent from the remote control unit to the projector. LASER POINTER FUNCTION This remote control emits a laser beam from the Laser Light Window. With the LASER button pressed, the laser light goes on. The signal emission indicator lights red and the laser is emitted with red light. With the LASER button pressed for more than 1 minute or released, the light goes off. [. . . ] Do not expose the remote control to moisture, or heat. If battery solution has leaked in the battery compartment, carefully wipe the compartment clean and install new batteries. Risk of explosion if the battery is replaced by an incorrect type. [. . . ]