User manual SANYO RM-X106W

[. . . ] Minimum distance (about 100mm) around the apparatus for sufficient ventilation. No naked flame sources such as lighted candles should be placed on the apparatus. Do not use where there are extremes of temperature (below C or exceeding 35 C). Battery shall not be exposed to excessive heat such as sunshine, fire or the like. [. . . ] Attention should be drawn to the environmental aspects of battery disposal. The caution marking was located at the bottom of the apparatus. The nameplate marking was located at the bottom of the apparatus. The use of apparatus in moderate climates. For safety reasons, do not remove any covers or attempt to gain access to the inside of the product. Page 3 INSTRUCTION MANUAL RM-X106W AM/FM Clock Radio 1. AC cord Setting Alarm icon Alarm icon Sleep icon Snooze icon Display time Page 2 Refer any servicing to qualified personnel. Do not attempt to remove any screws, or open the casing of the unit; there are no user serviceable parts inside, refer all servicing to qualified service personnel. correctly. While holding the TIME button down, then press MIN (Minute) button repeatedly, to set the correct minute. To reset the alarm to sound again at the same time the next day, set it back to BUZZ or RADIO. POWER SUPPLY Connect the mains lead to an AC 240V 50Hz wall outlet. -- The RADIO ON/OFF switch is mounted on the secondary side. The unit is not disconnected from the mains even switched off. LISTENING TO THE RADIO 1. In the interest of environmental safety, dispose of battery safely. SETTING THE ALARM 1. Set the ALARM OFF/RADIO/BUZZ switch to ALARM-BUZZ or ALARM-RADIO. If you set alarm by BUZZER, slide BUZZ SMALL/LARGE switch to desired location. While holding the ALARM button down, AL appears on the top-right of the LCD, then press the HOUR or MIN(Minute) button respectively to select the wake-up time. Note: If you want to check the alarm time setting, simply push the ALARM button. LIGHT HIGH/LOW FUNCTION Slide LIGTH HIGH/LOW switch to select the desired brightness of the display. AUX IN FUNCTION 1. Connect the external audio equipment to AUX IN jack on the back of the unit. Rotate the VOLUME knob to select the desired sound level. BATTERY BACK-UP SYSTEM This unit includes a battery back-up system which protects the clock, sleep timer and wake-up alarm functions from the mains failure with the battery installed. During the mains interruption, the clock display will go out, but the clock movement remains in operation. The time display will be resumed when the mains return. Reset the time if the display time is incorrect. When the mains lead is connected to the AC outlet for the first time, or when the mains returns after a failure longer than the battery life. [. . . ] Reset the time if the display time is incorrect. When the mains lead is connected to the AC outlet for the first time, or when the mains returns after a failure longer than the battery life. In this case, set the clock and alarm again. USING THE ALARM 1. If you want to wake up with the radio, tune in the station and adjust the volume level first. [. . . ]