User manual SANYO SC-X1000P

[. . . ] Do not allow plug to whip when rewinding. Do not pull or carry by cord, pedal cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts. [. . . ] Unplug before connecting any hose attachment accessory. Turn off all controls before unplugging. Make sure the power supply : 230-240V, 50Hz. Before the first operation, make sure the dust cup is properly installed. Do not use the machine without HEPA filter and motor protection filter in 1 · · Blocking the suction inlet will decrease the efficiency of the motor. Never try to vacuum the following objects. They may damage the unit or case a fire. *Burning or smoking such as cigarettes, matches or hot ashes. *Inflammable materials or combustible liquids such as gasoline and thinner. The following kinds of treatment shorten hose lifetime: *Bending hose at an acute angle when storing. *Pulling the hose with excessive force *Placing heavy objects on, or stepping on the hose. Figure_8 3 4 Attention: To lock the front cover firmly, snick it softly until it sounds "Click" If the blockage is found in floor brush, hose or tubes and the machine, the machine can be re-operated only after the blockage is cleaned away completely. This vacuum cleaner can be used as tip the rubbish out of the full dust cup. Figure_1 Figure_2 Figure_3 Figure_4 2. Clean Filters: HEPA filter; 1) Open the front cover: Press the buttons at the both side of socket hole and open it slowly. Figure_9, Figure_10 2) Dump the dust collection out of the dust cup. Figure_11 3) Rotate the filter and detach from the filter grill. Wash the filter in warm water and clean it with bush. Then, dry it completely before put it back to the dust cup. Be sure to dry naturally to prevent deformation. Figure_12 Figure_5 Figure_6 Figure_7 Figure_8 Motor exhaust filter; 1) Take out the filter (Figure_13, 14) and wash in warming water. It can be used after drying completely before put it back to the dust cup and be sure to dry naturally to prevent deformation. If the filter is damaged, a new filter should be replaced. Figure_9 Figure_10 Figure_11 Maintenance CAUTION Be sure to turn the power off and unplug the unit before cleaning. Clear the dust: when the dust collect to the MAX label of the filter, rubbish shall be tipped from the dust barrel. 1) Press the front cover clip beside the suction socket and open the front cover. [. . . ] 1) Press the front cover clip beside the suction socket and open the front cover. 2) Take out the dust cup and clean the dust away completely. 3) Clean the dust cup with warm water if necessary. Figure_12 Figure_13 Figure_14 5 6 Technical Specification Input power : Input voltage : Protection class: Power cord length: Dust capacity : 1800W 230-240V , 50Hz class ll 5m 2L Trouble Shooting If you have a problem with your cleaner, consult the handy guide as below. If the cleaner is malfunctioning, do not operate it before asking for service. Problem Noisy operation Low Suction Possible Solution Clean the filter and clean up the inside of the dust cup. [. . . ]