User manual SANYO SC-X2017

[. . . ] · Use only as described in this manual. · Do not use with damage cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, it must be repaired by qualified service agent. · Do not pull or carry by cord, pedal cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. [. . . ] · Unplug before connecting any hose attachment accessory. · Avoid using in a vertical position. · If the supply cord of this appliance is damaged, ask the shop which you bought, or it must only be replaced by properly qualified service personnel because a special purpose tool is required. · If you find the motor temperature too high or any unusual noise, should be smell or smoke found when using, stop the operation and unplug. Do not repair the appliance by yourself. Introduction of Parts 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Power cord Handle On/off switch pedal Speed control button Cord rewinding pedal Upper cover Hose socket Dust bin Dust barrel Big wheel Plastic tube Floor brush Integrated brush & nozzle Flexible hose 12 13 2 Accessories: 1 set hose accessory 1 piece floor brush 1 set tube 1 integrated brush nozzle. Use Instructions 1. To connect the hose, press the buttons on the hose end and insert the hose into the hose socket until the hose locks. To detach, press the buttons and pull the hose toward you. Connect the telescopic tube firmly to the handle of hose. Connect the floor brush or the combination nozzle firmly into the telescopic tube. Before starting operation, pull out the power cord and then insert the plug into the power socket which conforms to that on the rating label for power supply. The machine would start working without speed control. To control suction power, slide the speed control on the body. Suction power can also be controlled by sliding the airflow control on the hose. Use the crevice nozzle to vacuum edges and gaps. The head of the combination nozzle can rotate. Use the round brush to vacuum sofa, curtain or fragile or easily scratched items. Turn off the machine: press the on/off switch button again, the machine is turned off. Before rewinding, be sure to the cord is unplugged. To rewind the power cord, press the cord rewind button. Carrying it by using the carry handle. Figure_1 Figure_2 Figure_3 Figure_4 (Figure_5) Figure_5 Figure_6 Figure_7 Figure_8 Figure_9 Figure_10 Maintenance Caution: Be sure to turn the power off and unplug the unit before cleaning. [. . . ] Clean the filter and empty the dust cup. Clean the filters, and empty the dust cup. Check for blockages and unblock and allow it to cool. Plug unit firmly. Noisy operation Low Suction Over-heating/ Automatically Stopping Nozzle is clipped into a compartment at the bottom Cannot Find the edge on the back of the vacuum cleaner (between Combination the wheels). [. . . ]