User manual SANYO NC-MQN06

[. . . ] 2) If you want to charge 4 pcs of AA or AAA, put batteries into the charger compartments, taking care to observe polarity (+/-) as indicated inside the charger. 3) If only charging 2 batteries at a time, place the batteries in the left or right side compartments of the charger. Notes on Safety (Please read for proper use. ) Severity of symbol Danger - Very close to causing death or heavy damage to human body. Warning - May cause death or heavy damage to human body. Caution - May cause heavy damage to human body or property damage. [. . . ] When carrying or storing batteries, avoid direct contact with metal objects. · Children should be supervised while handling the batteries. · Do not peel off or damage the outer tube. · If leaked liquid gets on the skin or clothing, wash off with clean water immediately. · Do not connect 10 batteries or more in series. 4) Swing plug out and plug into AC100-240V outlet. 5) Confirm that the indication lights begin to flash. If plugged in upside down, it will finish charging before it is fully charged. 6) When charging is complete, the indicator lights will turn on constantly. Refer to charging chart for typical charge time. 7) After charging is done, unplug the charger from the outlet and swing plug back into place. Warning Do not allow metal objects come into contact with charger. May cause electric shock, excessive heat, or fire. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Do not charge non-rechargeable batteries. Caution Operating temperature range for Ni-MH battery eneloop · Discharge 23°F to 122°F · Recharge 41°F to 95°F · Store - 4°F to 86°F · Outside of the indicated range, battery's performance and life-cycle may decrease. Do not use these batteries together with dry cells, other types of batteries, new or old batteries together, or batteries with different charge levels. How to insert a AAA battery Spec Input AC100-240V ~ 50/60Hz 8W Output Size 118 x 72 x 32. 5 mm ~ 98g Weight AA - 2/4 x 1. 2V -- 300mA AAA - 2/4 x 1. 2V -- 150mA Temp. range 41°F ­ 95°F Charge time Suitable Battery 1 ­ 4 battery Ni-MH AA HR-3UTG ( Max 3000mAh. 1900mAh*) battery eneloop AAA HR-4UTG (Max 1000mAh. 750mAh*) Caution May deform charger causing high heat, leakage, or explosion. [. . . ] · Insert the + terminal of the AA eneloop battery into the ­ end of the spacer. · Push the AA battery until it "snaps" into place. · To remove, push on the + terminal of the AA eneloop battery until it releases. Charging Safety Do not charge near hot temperatures like an electric blanket, stove, near direct sunlight, inside of a car, or under hot sun, etc. In addition, please do not cover the charger with a blanket. [. . . ]