User manual SANYO TLS-9924P

[. . . ] refer servicing to qualified personnel only. If the power supply cord (AC power cord) of this appliance is damaged, it must be replaced. Return to a SANYO Authorised Service Centre for replacement of the cord. Replace only with the same or equivalent type recommended by the manufacturer. [. . . ] œ This function does not operate when a warning display appears on the digital display. NOTES: œ If the end of the tape is reached during a search, the tape will rewind and stop. If the beginning of the tape is reached, it will stop. œ This function does not operate when a warning display appears on the digital display. 26 English RQ4Q/EX (TLS-1960P GB) Wed. May, 08/2002 PROGRAMME TIMER RECORDING There are three programme timer recording methods, daily recording, weekly recording or recording on certain days of the week. 8 Turn the JOG dial to set the recording stop minutes (ex: 00), then turn the SHUTTLE ring clockwise. The “SPD” (recording speed) position will start flashing. Example 1: To record on every Saturday from 9:00 AM to 5:00 PM (17:00), in 24-hour mode (recording speed). œ Follow the Before starting steps, under “NORMAL RECORDING”. NOTE: œ If the set stop time is earlier than or the same time as the set start time, the VCR will consider the stop time to be the following day, and “T” will be displayed next to the recording stop time. ---@N Example 2: To record every week from Friday at 9:00 PM (21:00) to Monday at 7:00 AM, in 96-hour mode (recording speed). œ Follow the Before starting steps, under “NORMAL RECORDING”. 2 Turn the JOG dial until the “SAT” (Saturday) line is highlighted, then turn the SHUTTLE ring clockwise. 3 Turn the JOG dial, to set the desired start day of the week (ex: FRI), then turn the SHUTTLE ring clockwise. 4 Turn the JOG dial to set the recording start hour (ex: 21), then turn the SHUTTLE ring clockwise. 5 Turn the JOG dial to set the recording start minutes (ex: 00), then turn the SHUTTLE ring clockwise. 6 Turn the JOG dial to set “**” for the recording stop hour, then turn the SHUTTLE ring clockwise. ø The rest of the line settings will change to “**:** *** *”, the day of the next line will change to the next day and the start time will change to “**:**” automatically. 7 Turn the JOG dial to set the desired stop day of the week (ex: MON), then turn the SHUTTLE ring clockwise. 8 Turn the JOG dial to set the recording stop hour (ex: 07), then turn the SHUTTLE ring clockwise. 9 Turn the JOG dial to set the recording stop minutes (ex: 00), then turn the SHUTTLE ring clockwise. [. . . ] For places with symbols such as E (k) and F (k), carry out checking and cleaning, and replace if necessary. This periodic maintenance check table changes considerably according to the using conditions and environment. Refer to the (POWER FAILURE/DEW/USED TIME) menu for the length of time the unit has been used. As the life of parts may be shortened if foreign particles and dusts remain accumulated on the tape guides and rotating and contacting portions, clean if dirty. [. . . ]