User manual SANYO VCC-4344

[. . . ] If used with a foreign object inside, it could cause fire, short-circuits or damage. If water or liquid gets inside the camera, disconnect the power cord immediately, and consult your dealer or a Sanyo Authorized Service Center. Be careful to protect the camera from rain, sea water, etc. Cleaning Dirt can be removed from the cabinet by wiping it with a soft cloth. To remove stains, use a soft cloth moistened with a soft detergent solution and wrung dry, then dry by wiping with a soft dry cloth. [. . . ] LENS (lens iris output terminal) Used to connect the lens plug when the lens is attached. Brake coil (-) Brake coil (+) Drive coil (+) Drive coil (-) When installing the camera support, select a location that can support the total weight of the camera and accessories. Attaching the lens Use a DC type auto-iris lens (sold separately). Is the lens in focus?Dirt or fingerprints on the lens can adversely affect the image. Gently wipe any dirt or fingerprints off the lens with a soft cloth or lens cleaning paper and cleaning fluid (commercially available). Is the monitor adjusted correctly? Do not use a lens if length "L" is more than 5 mm. Otherwise, it may damage the camera and prevent proper installation. When attaching a C mount lens, attach the lens to the camera after inserting the C mount ring (option). SERVICE L 1 Remove the lens mount cap from the camera. 2 1 CS mount type lens 2 Install the auto-iris lens. 3 Connect the lens plug to 3 the lens iris output connector (LENS) on the side of the camera. The camera is a precision instrument. Handle it carefully and always follow the safety precautions. If the camera requires service, never try to repair it yourself or open the casing. For servicing, maintenance, or repairs, contact your place of purchase or a Sanyo Authorized Service Center. CONNECTIONS Connections Monitor 24 V AC connection AC24V GND White balance (color compensation) 5 5 10 695 The electronic iris is suitable for normal indoor use. When switch 1 (IRIS) is set to the up (EI) position, do not use an auto-iris lens. If used under fluorescent light, the image may flicker. In such a case, change to incandescent lighting or set switch 1 (IRIS) to the down (AI) position and use an auto-iris lens. When shooting bright subjects, pay attention to the light angle in order to avoid or minimize the smear effect. If conditions are outside the electronic iris operation range or more than the maximum illumination, the CCD will be saturated. In that case, use the auto iris lens. MANU Lets you fine-tune the white balance manually. WB ATW · R (Red) dial 9 : Turn clockwise to augment screen red. · B (Blue) dial 10 : Turn clockwise to augment screen blue. 12 V DC connection Compensation is performed automatically. 3 AC24V GND 1 3 DC12V DC12V 2 2 Vertical sync disturbance may occur when a selector is used to switch between multiple cameras connected to one monitor. To prevent vertical sync disturbance, set to "LL. " LL (external sync) INT (internal sync) Adjust PHASE dial to eliminate sync disturbance. Internal Sync Sync setting 7 GCB Aperture (outline compensation) 2 If object outlines appear too strongly, set to "NORM". Figure 1 Figure 2 SHRP NORM Emphasizes object outlines. [. . . ] Do not tighten the screw further. 3 Insert the power adapter plug into the wall outlet. The power indicator (POWER) lights. Color/black and white setting Connect each pin of the CONTROL terminal as indicated below, to set the image to color or black and white manually. You can adjust the image by remote control. Color image setting Connect the C (color) and the G (ground) pins. Black and white setting Connect the B (black and white) and the G (ground) pins. The camera comes pre-adjusted and ready to install at time of factory shipment, but you may want to make adjustments or settings to adapt to the operating conditions or installation environment. [. . . ]