User manual SANYO VPC-S500

[. . . ] FCC STATEMENT (For customers in USA) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] The EV compensation value can be set in the range from -2. 0EV to +2. 0EV. Press the power switch to turn on the power. Press the four-way controller ( / ) and use to set the range of EV compensation value from -2. 0EV to +2. 0EV. Press the button to confirm the setting. EV ±0. 0 0. 0 Select : Set : EN-33 Setting White Balance This feature lets you make adjustments to compensate for different lighting types according to your shooting conditions. Press the power switch to turn on the power. Use the four-way controller ( ) to select [W. Use the four-way controller ( ) to select the desired white balance setting, then press the button to confirm. To cancel the setting, press the MENU button and exit the menu. Press the shutter release button to capture the image. Mode1 Mode2 Mode3 Image Si Im ge Size Quality W. Balanc ISO eturn Retu n : Return Select : W. Balanc Auto Aut uto Daylight Cloudy Tungsten Tungste ungsten Cancel : Select : W. Balanc Fluorescent Fluo escent luorescen Cancel : Select : EN-34 PLAYBACK MODE - THE BASICS Viewing Images You can display the still images one by one. Rotate the mode dial to , , , , 100-0001 , or and turn your camera on by pressing the power switch. The last recorded image appears on the LCD monitor screen. Basic information is shown by indicators on the LCD monitor screen. To see full information display, press the button. Use the four-way controller ( ) to select the desired images. To view the previous image, press the four-way controller ( ). To view the next image, press the four-way controller ( ). · For protected images/movie clips, mark will be displayed. Refer to the section in this manual titled "Protecting Images/Movie Clips" for further details. · For images selected for printing with DPOF setting, mark will be displayed. (Refer to the section in this manual titled "Setting the DPOF" for further details. ) · If there is no image stored in the internal memory or on the SD/SDHC memory card, [No image] message will appear on the LCD monitor screen. [. . . ] Approximate Duration of Recording Time The table below indicates the approximate duration of recording time depending on the capacity of the internal memory and the SD/SDHC memory card. Image size 320 x 240 Internal Memory 00:00:32 SD/SDHC Memory Card 64MB 00:02:23 128MB 00:04:49 256MB 00:09:41 512MB 00:19:25 1GB 00:38:54 2GB 01:17:52 4GB (SDHC) 02:33:59 The values for the recording time may vary depending on the shooting conditions and settings. The frame rate is 30 fps (frames per second). EN-62 CONNECTING TO A PICTBRIDGE-COMPATIBLE PRINTER Even if you do not have a computer, you can connect the camera directly to a printer that supports PictBridge to perform image selection and printing using the camera screen and controls. DPOF support also lets you specify which images you want to print and how many copies of each should be printed. Rotate the mode dial to and turn your camera on by pressing the power switch. [. . . ]