User manual SANYO VPC-S7EX

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] Press the power switch to turn on the power. Press the four-way controller ( / ) and use to set the range of EV compensation value from -2. 0EV to +2. 0EV. Press the button to confirm the setting. Select : EV ±0. 0 0. 0 Set : EN-34 Setting White Balance This feature lets you make adjustments to compensate for different lighting types according to your shooting conditions. Press the power switch to turn on the power. Use the four-way controller ( ) to select [W. Use the four-way controller ( ) to select the desired white balance setting, then press the button to confirm. To cancel the setting, press the MENU button and exit the menu. Mode1 Mode2 Mode3 Image Si Im ge Size Quality W. Balanc ISO eturn Retu n : Return Select : W. Balanc Auto Aut uto Daylight Cloudy Tungsten Tungste ungsten Cancel : MENU Select : W. Balanc Fluorescent Fluorescent luorescent Cancel : MENU Select : EN-35 USING THE MODE DIAL Auto Mode [ ] (Auto) mode is the simplest way which allows you to take still pictures without having to set special functions or manual adjustments. The camera sets the optimal focusing and exposure. Rotate the mode dial to , , , , , or and turn your camera on by pressing the power switch. The last recorded image appears on the LCD monitor screen. Basic information is shown by indicators on the LCD monitor screen. To see full information display, press the /DISPLAY button. Use the four-way controller ( ) to select the desired images. To view the previous image, press the four-way controller ( ). To view the next image, press the four-way controller ( ). 100-0001 For protected images/movie clips, mark will be displayed. Refer to the section in this manual titled "Protecting Images/Movie Clips" (EN-48) for further details. For images selected for printing with DPOF setting, mark will be displayed. (Refer to the section in this manual titled "Setting the DPOF" (EN-49, 50) for further details. ) If there is no image stored in the internal memory or on the SD memory card, [No image] message will appear on the LCD monitor screen. You cannot enter the Playback mode from the Setup mode. EN-39 Magnifying Images While reviewing your images, you may enlarge a selected portion of an image. [. . . ] 130g (without batteries & SD card) Exposure compensation -2. 0EV~ +2. 0EV (in 1/3 EV increments) * Recording capacity shows approximate number of shots recorded during CIPA-compliant testing. Actual performance may vary according to operating conditions. * Design and specifications are subject to change without notice. EN-79 APPENDIX Troubleshooting Guide Symptom Power does not turn on. Possible causes * The batteries have run out. [. . . ]