User manual SANYO VSE-2300HB

[. . . ] INSTRUCTION MANUAL VSE-2300 & VSE-2400 SERIES Cylindrical Environmental Camera Housings About this manual Before installing and using this unit, please read this manual carefully. Be sure to keep it available for later reference. IMPORTANT SAFEGUARDS 1. Read Instructions - All the safety and operating instructions should be read before the unit is operated. Retain Instructions - The safety and operating instructions should be retained for future reference. [. . . ] These screws are captive and will not come out all the way. See Figure 1. Loosen These Screws Do Not Remove Figure 1: Loosening Captive Screws 2. Grasp the housing's front cap and pull forward. This will make it difficult to slide off the cover. See Figure 2. Grasp Here LENS CONTROL CABLE Cable Type: Jacketed multiconductor cable. Cable Size: Outside diameter between 4. 3 mm (0. 170 in)­11. 9 mm (0. 470 in). Belden 9554. Figure 2: Removing the Cover 3. Allow the cover to dangle from the base. 6 6. 5 Camera/Lens Installation 1. Loosen the two screws holding the camera bracket to the base. It is not necessary to remove them completely. Use the various 1/4-20 screws and spacers provided to mount the camera and the lens to the camera bracket. 6. 6 Camera/Lens Wiring WARNING: Only use the cables specified under "INSTALLATION, Cable Requirements" for wiring of all cameras and lenses. Camera Bracket Loosen These Screws 6. 6. 1 Fittings 1. The two large 1/2-inch NPT fittings accept round cable with diameters from 4. 3 mm (0. 17-inch) to 11. 9 mm (0. 47-inch). The small fittings will accept cables with diameters from 4. 6 mm (0. 181-inch) to 7. 9 mm (0. 312inch). Be sure to securely tighten all fittings to ensure a liquid-tight seal. Failure to do so could allow water to enter the housing and damage the camera and lens. If a sealant is to be used, be sure it is a neutral cure type. Sealants that release acetic acid may harm camera electronics. Figure 3: Removing the Camera Bracket 2. Remove the camera bracket from the base. If you are using the feed-through feature, refer to Section 6. 8. 3 at this time. Mounting fixed lens cameras in VSE-2300 and VSE-2400 Series Housings. Use the 1/4-20 x 3/8-inch screw to mount the camera to the camera bracket. [. . . ] Use silicone grease to lubricate the seals if necessary. See Figure 10. 9 See Detail Cover Rib Seal Top of Base Figure 10: Reinstalling the Cover 3. As the cover nears the rear cap, make sure the captive screws in the back are not blocking the cover from engaging into the rear cap. Screw the two rear captive screws into the housing. [. . . ]