User manual SCHOLTES TIC 642 DD L

[. . . ] Pour permettre une bonne aération et pour éviter toute surchauffe des surfaces autour de lappareil, la table de cuisson doit être positionnée : à au moins 40 mm de distance du mur arrière ou de toute autre surface verticale; de manière à ce quil reste au moins 20 mm de distance entre la découpe dencastrement et le meuble en dessous. Switching on the hob Switching on the cooking zones Booster function Switching off the cooking zones Programming the cooking duration Timer Control panel lock Switching off the hob Demo mode Practical advice on using the appliance Safety devices Practical cooking advice Please keep these operating instructions for future reference. Pass them on to any new owners of the appliance. Before operating your new appliance please read The appliance must be installed by a qualified professional in accordance with the instructions provided. [. . . ] At step 2, press the duration decreases progressively until it reaches 0 and switches off. When the 6 seconds have elapsed, the ON/O. The timer can be used to set a duration up to 99 minutes. Press the programming button until the timer indicator light is illuminated. When the hob is switched on again it will be set to the demo mode. To exit this mode, follow the procedure described above. When it is next switched on, the hob will function normally. When the time has elapsed, a buzzer will sound (for one minute). Practical advice on using the appliance Use cookware made from materials which are compatible with the induction principle (ferromagnetic material). We especially recommend pans made from: cast iron, coated steel or special stainless steel adapted for induction. When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children, during cleaning, etc. Press the button to lock the control panel: the indicator light above the button will switch on. To stop cooking), you must switch off this function. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. In addition, to obtain the best results from your hob: Use pans with a thick, flat base in order to fully utilise the cooking zone. Always use pans with a diameter which is large enough to cover the hotplate fully, in order to use all the available heat. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the demo mode the hob must be switched on, with all the hotplates switched off. Make sure that the base of the cookware is always clean and dry, in order to fully utilise and extend the life of both the cooking zones and the cookware. Avoid using the same cookware which has been used on gas burners: the heat concentration on gas burners may distort the base of the pan, causing it not to adhere correctly. [. . . ] When disposing of packaging material: observe local legislation so that the packaging may be reused. The European Directive 2002/96/EC relating to Waste Electrical and Electronic Equipment (WEEE) states that household appliances should not be disposed of using the normal solid urban waste cycle. Exhausted appliances should be collected separately in order to optimise the cost of re-using and recycling the materials inside the machine, while preventing potential damage to the atmosphere and to public health. The crossedout dustbin is marked on all products to remind the owner of their obligations regarding separated waste collection. [. . . ]