User manual SCHWINN 17 FUNCTION BIKE COMPUTER

[. . . ] Press the right button to progress numbers. Press right button to move to the next screen. 3rd Screen - Tripmeter (DST) Speedometer: Displayed on top line. Speed Comparator: in same position as previous screen. Speed Tendency: in same position as previous screen. [. . . ] Speed Tendency: in same position as previous screen. Odometer; Total distance traveled is displayed on bottom line. To reset ODO to zero, press and hold both buttons for a few seconds until the screen changes or remove the battery. Both of these procedures will reset all functions. Press right button to move to next screen. 9th Screen - Fat Burning (CALF ) Speedometer: Displayed on top line. Speed Comparator: in same position as previous screen. Speed Tendency: in same position as previous screen. Fat Burning: Fat Burned is displayed on the bottom line. Press right button to move to Scan mode. Scan In Scan mode, the screen cycles through DS7", MXS, AVS, and TM modes. Each screen is displayed for about 4 seconds. Press right button to return to Speedometer mode. Troubleshooting Malfunction No speedometer reading Remedy Check alignment of magnet & sensor. Check distance between magnet & sensor. Verify temperature is within operating limits 1 30 ) Replace battery Reseat battery Replace battery Reseat battery Replace battery Check alignment of magnet & sensor. Check distance between magnet & sensor. Reseat battery Replace battery Reseat battery Replace battery Slow display response Black Display Freeze Frame Memory Press the left button, Freeze Frame Memory can lock the display at the end of a ride segment. TM, DST, and AVS, which will be flashing, can be read at a later time by pressing the right key. To reset the memory, press the left button; the display will stop flashing. This is particularly useful when crossing the finish line of a time trial. Note: Computer must be in either ODO, DST; MXS, AVS, or TM mode for this function to work. Display readout fades No trip distance readout Display shows irregular figures PACIFICCYCLE Odometer Reset Function The Odometer Reset Function allows you to reenter your total distance after the odometer has been reset to zero. In the ODO mode, press the left button for a few seconds until the last digit flashes. Press the right button to adjust the number. Press the left button to select the number. [. . . ] The unit will switch to Wheel Size Input Mode. Multiply the wheel diameter (d) in millimeters by 3. 1416 to determine the wheel factor [C]. To input wheel factor into the computer, press the right button to progress the digit and press the left button to select the digit (hold the right button for fast advance). Press the left button again for mile/kilometer selection. [. . . ]