User manual SCOTSMAN CME1402

[. . . ] CME1202 & CME1402 INTRODUCTION To the owner or user: This service manual is intended to provide you and the maintenance or service technician with the information needed to install, start up, clean, maintain and service this ice system. Table of Contents FOR THE INSTALLER . page 3 UTILITY CONNECTION LOCATIONS: Back Views . page 4 FOR THE INSTALLER: Location & Assembly . page 5 FOR THE ELECTRICIAN FINAL CHECK LIST . [. . . ] Move the WASH/OFF/ICE switch to the OFF position. Remove the reservoir drain cap and drain the cleaning solution from the sump. Rotate the shaft of the timer and switch assembly CLOCKWISE to the harvest position (low part of the cam against microswitch). Move the WASH/OFF/ICE switch to the ICE position to start the Harvest cycle. If, after completing this procedure, one or more evaporator plates does not have a full flow of water for each vertical column of cubes, shut down the operation and remove and clean all water distributor manifolds. Reinstall the water distributor manifolds. Electrical Shock Hazard. Electrical shock can cause personal injury. Cleaning procedures are done with the power ON. Remove the control box cover, and rotate the shaft of the timer and switch assembly CLOCKWISE advancing to the freezing cycle. (Beginning of the higher part of the cam against the microswitch). Open the ice storage bin door and empty the bin of ice. Remove the hose clamp, rubber cap and drain all the water from the sump assembly into a container. Mix 24 ounces of Scotsman Ice Machine Cleaner with 2 gallons of warm (950F. - 1150F. ) water. Note: The ice making portion of the water system should be sanitized after cleaning by repeating steps 2-12, except substitute an approved sanitizing solution for the cleaning solution. 13. Move the compressor ON-OFF switch to the ON position to start the ice making process. CAUTION DO NOT use ice produced from the cleaning solution. Check the next ice cube harvest to be sure that the ice cubes are clear and the acid taste is gone. Add hot water to the bin to melt the ice. Replace all panels. Scotsman Ice Machine Cleaner contains acids. In case of external contact, flush with water. KEEP OUT OF THE REACH OF CHILDREN. January 1995 Page 18 CME1202 & CME1402 CLEANING AIR COOLED CONDENSER 1. The fan blade can cause personal injury. [. . . ] Usually a leak detector capable of detecting a Halongenated -6 28 84 182 refrigerant or HFC-134a will work. Check with the leak detector -4 29 86 188 manufacturer if in doubt. -2 31 88 194 Access Valves: To use the access valves: 0 33 90 200 · Remove the cap from the stem, use a 3/16" allen wrench to check 2 35 92 206 that the valve is CLOSED. 4 37 94 212 · Close the valve and replace the caps when the job is finished. [. . . ]