User manual SCOTSMAN CME1856W

[. . . ] CME1856W Introduction This product manual contains the information needed for the setup, installation, initial start up, sanitation and maintenance of this ice machine. This machine incorporates advanced technology, including a scroll compressor. This manual is organized in the same way as the expected use of the machine, it begins with specifications, goes thru unpacking and setup, shows where everything is; continues with initial start up, then describes how it works. After that is the sanitation section, followed by service diagnosis and repair. Be certain that the information applies to the model All Scotsman CM3 models, like this one, feature in question. [. . . ] The ice machine's water system should be cleaned and sanitized a minimum of twice per year. In Place Cleaning of the Ice Machine Water System: 1. Push and release the Harvest button (this releases 10. Continue the rinsing process for 20 minutes, then any ice that may be on the evaporators and warms push the off button to switch the machine off. Go to the next step to sanitize the machine or go 4. Wait for the machine to finish the Harvest cycle to step 19 to finish the cleaning process. Remove the the insulated plastic evaporator cover, the two inner splash panels (part number 02-3680-01 and the one above it), both cube deflectors, and the ice sensors. Place the splash panels and the cube deflectors in a separate container. Place the ice sensors in the reservoir, but be sure that the ends of the connecting wires are not in the water. The Clean indicator light will be blinking, and the pump will restart. Note: A possible sanitizing solution may be made by mixing 1 ounce of liquid household bleach with 2 gallons of warm (95-115oF. ) potable water. Push and release the Clean button again. Pour 24 ounces of Sanitizer solution into the reservoir water. 9. After the ice machine cleaner has circulated for 10 minutes, push and release the Clean button. Note: The rinse process flushes any residual cleaner out of the ice machine's water system. 15. After the solution has circulated for 10 minutes 7. Pour 24 ounces of Scotsman Ice Machine Cleaner push and release the Clean button. This starts the into the reservoir water. Return the evaporator cover rinse process. Sanitize the ice storage bin while waiting. Continue the rinsing process for 20 minutes, then 8. Mix a solution of 8 ounces of Scotsman ice push the off button to switch the machine off. machine cleaner and 1 gallon of warm (95-115oF. ) water. [. . . ] Close the low side service access valve. Open the discharge side manifold valve and weigh in the name plate charge. After the charge is weighed in, wait a few minutes and re-check the scale. If all of the refrigerant charge has not been weighed into the discharge side, it must be carefully added thru the low side. [. . . ]