User manual SCOTSMAN RF33

[. . . ] RF33 Introduction The Scotsman RF33 Compact Refrigerator is a unique product, capable of being built into a cabinet because of its front vented, forced-air cooling system. It's also designed to be a companion to Scotsman's DC33 Automatic Ice Machine. To prevent door interference when installed to the left of a DC33, the RF33 comes from the factory with the door hinged on the left. The door swing may be reversed to suit the installation. [. . . ] Remove the three plastic plugs from the top front corner where the hinge will mount. Remove the three plastic plugs from the lower front corner where that hinge will mount. Remove the three screws holding the top hinge to the cabinet. Remove that hinge from the top and, flipping it upside down, install it onto the bottom of the door, on the opposite side using the original screws. Remove the hinge assembly from the bottom of the door, and flip it upside down; secure it to the cabinet at the opposite side top position with the original screws. Secure the door to the top hinge with the original screws. Secure the bottom hinge to the cabinet with the original screws. Place the plastic plugs removed earlier into the empty holes. Check operation of the door by opening and closing it. Hinge Door Handle Filler Plate Hinge Magnetic Gasket Door Reverse Hinges From Top to Bottom and Left to Right To Reverse Door Swing November 1992 Page 5 RF33 Installation The machine should not be installed in a room that falls below 50oF. Level the cabinet by turning the leveling legs at the base of the refrigerator. Plug the refrigerator into the electrical power supply. Do not slide into place until the unit has been started. Operation: To begin operation: Open the door, locate the temperature control knob in the upper right portion of the interior and rotate that knob clockwise until it is about at the mid position. The compressor and fan motor should both be operating, unless the refrigerator is below 35oF. Check that air is flowing out the right side of the grill. The metal portion of the freezing compartment will soon feel cold. That is the signal that the refrigerator is functioning and the cabinet may now be placed in its installed position. The refrigerator will require some time to cool the air and cabinet interior. If desired, a thermometer may be placed in the interior and the temperature checked. The RF33 should maintain approximately 40oF. interior temperature. Temperature Control Location of Temperature Control Freezing Compartment Plastic Drip Tray Note: As warm products are placed in the refrigerator, the refrigerator will likely operate for some time to cool them. When the refrigerator is empty, it will switch on and off frequently because there's only air inside, and the temperature of the air changes quickly. The temperature of the Refrigerator may be adjusted by rotating the temperature control knob: Turn the knob clockwise for colder and counterclockwise for warmer. [. . . ] Remove the screw and bulb holder clip to free the end of the thermostat capillary tube from the rear of the evaporator. Remove the knob from the thermostat (pull forward). Remove two screws (retain spacers) and separate the thermostat housing from the freezing compartment (evaporator). Separate the thermostat from the electric baffle, pull the capillary tube out through the hole in the rear of the left wall of the thermostat housing. [. . . ]