User manual SCOTSMAN SLD150

[. . . ] SLD150 Introduction To the owner or user: This product manual is a source of information about the installation, start up, cleaning, maintenance and repair of the product. The SLD150 is a Slim Line® brand hotel/motel ice dispenser. It is designed to use a Scotsman Slim Line SLE300 or SLE400 ice machine as the source for ice. Ice from the cuber falls into the insulated hopper, where it is stored until needed. [. . . ] Install the small cover plate from the kit. Remove cover plate on right side of front panel, below push button switch; use 5/16" nut driver. Install the mounting plate fron the kit using the nuts from the kit. Secure the coin mechanism to the mounting plate from the inside of the dispenser. Use the screws, flat washers and lockwashers from the kit. Remove the timer mechanism from the kit and install it in the control box. Remove wires numbered 8 and 9 from the control box, they will be replaced by new wires from the kit marked 8 and 9. Install the new wires, following the wiring diagram from the kit. Reconnect the electrical power supply to the machine. Place a container in the drop zone of the dispenser. Place a quarter in the slide of the coin Adjustment Coin Mech Timer Agitation Timer Electrical Sequence 1. Coin switch closes, connecting power to timer. Timer closes internal contacts, connecting power to gearmotor (and door solenoid if -1B) 3. Gearmotor rotates dispense wheel until internal timer contacts (AND cam switch contacts if -1) open. The time of rotation (and amount of ice dispensed) is determined by the timer. October 1996 Page 5 SLD150 Key Kit Installation: (KSLDK2) 1. Disconnect electrical power Electrical Shock Hazard. Disconnect electrical power before beginning procedures. Obtain typical door lock cylinder from the motel/hotel. Insert cylinder into brass fitting (most cylinders will fit). Mark place where cylinder sticks out past brass fitting. Insert cylinder into hole on plate in kit. Place switch mounting bracket behind cover plate and over fitting, with the switch below the fitting. [. . . ] Cleaning and Sanitizing of the Ice Storage Bin: The minerals, chlorine and other impurities in the water are rejected from the water during the freeze cycle of the ice machine. These minerals will collect in the storage bin. The ice storage bin should be cleaned and sanitized every 90 days. Remove all of the ice stored inside the dispenser bin and shut off the ice maker. [. . . ]