User manual SCOTSMAN TDE650 SERVICE MANUAL

[. . . ] TDE550 & TDE650 INTRODUCTION To the owner or user: The service manual you are reading is intended to provide you, and the maintenance or service technician with the information needed to install, start up, clean, maintain, and service this ice maker-dispenser. The TDE650 is a combination nugget ice maker and countertop dispenser, with the option of wall mounting. The TDE650 ice making section is equipped with the following features: electronic controls for bin level and low water; thermostatic expansion valve; front service for most components; and R-404A (HP62) refrigerant. The ice dispensing section is a seamless plastic storage bin, with a stainless steel rotating vane to sweep the ice into the dispensing chute. Table of Contents FOR THE INSTALLER: Specifications . [. . . ] A possible sanitizing solution to use could 5. Remove the cover to the water reservoir and be 1 ounce of household bleach mixed with 2 block the float up. Drain the water reservoir and freezer assembly 12. Remove the block from the float in the water using the drain tube attached to the freezer water reservoir. Return the drain tube to its normal upright 13. Switch the master switch to ON position and replace the end cap. Continue ice making for at least 15 minutes, to 7. Prepare the cleaning solution: Mix eight ounces flush out any cleaning solution. Check ice for acid of Scotsman Ice Machine Cleaner with three taste - continue icemaking until ice tastes sweet. The water should be between 90-115 degrees F. DO NOT USE any ice produced from the cleaning solution. Scotsman Ice Machine Cleaner contains acids. Add warm water to the ice storage bin and induce vomiting. Give thoroughly wash and rinse all surfaces within the large amounts of water or bin. Sanitize the bin cover, dispensing vane, bin external contact, flush bottom, and interior with an approved sanitizer with water. Keep out of using the directions for that sanitizer. Replace the ice storage bin cover, and the front panel. 8. Slowly pour the cleaning solution into the water reservoir until it is full. Wait 15 minutes, then switch the master switch to ON. August 1999 Page 18 TDE550 & TDE650 MAINTENANCE AND CLEANING Slide UP To Remove Moving Parts Hazard. Disconnect electrical power to the icemaker dispenser before beginning. Air Cooled Models: Check the air cooled condenser for lint, dirt or grease build-up. Clean with vacuum or soft brush until light can be seen thru the fins. BIN CONTROL SENSOR BIN CONTROL SENSOR Reservoir CLEAN WATER SENSOR PROBE ////////CAUTION////// THE TIP IS MADE OF GLASS BIN TOP See Removal and Replacement to replace ICE SWEEP 2. [. . . ] Note: Note: There are no valve Only a HFC type dryer should be used. ·When brazing the tubing connections to components such as the TXV, the component must be protected by heat sink material. Recover, reclaim or recycle refrigerant. The method chosen is up to the service company. [. . . ]