User manual SCOTT VOLTAGE FREERIDE

[. . . ] 22. 2mm x 8mm 22. 2mm x 8mm 31. 6mm 1. 5" 160 - 200mm 525 - 571mm 73mm ISCG / ISCG05 tab 135mm 2 x 61901 (24 x 12 x T6) 6 x 61902 (28 x 15 x T7) 64mm Single speed, 34 to max. 38T 135 / 150 165 / 180 150 / 170 2. 1 / 2. 3 2. 2 / 2. 4 2. 1 / 2. 3 ADJUSTABLE REAR TRAVEL Depending on the different models of Voltage FR you'll find different shock mounts that will help to match the different shox (different eye-to-eye length) to the frames without changing seat/headtube-angles or riding position on the bike. [. . . ] If this is not done correctly the rear shock can be damaged. For fine tuning the SAG and the corresponding eye-to-eye distance of the shock bolts you can tighten or release the pretension of the coil spring but please respect the maximum and minimum spring indications of the shock manufacturer. The eye-to-eye distance between the shock bolts should be in basic set up with 40% SAG. This length is also indicated on the cover of this manual by the colored beam of the SAG-Boy. For further details on the shock set-up please follow the indications of the rear shock manufacturer attached to this bike. Important!Note that you have to mount the rear shock always as shown underneath. Mounting the rear shock in a different position can cause severe damages to the frame, the linkage levers and the rear shock. E E2 ht ng kle oc Sh 10 2011 SCOTT BIKE OWNERS MANUAL SET-UP OF OTHER SHOCK MODELS Scottstronglyrecommendsusingonlytheoriginallyspecifiedshockwiththe VoltageFRbike, as we have chosen carefully both parts for a perfect matching combination. VOLTAGE FR If you want to use a different rear shock model than the one originally on the bike, please make sure that the shock will not in any position hit the frame and cause a damage to the frame. Please follow the instruction below: Please make sure that the rear shock or its accessory parts do not touch the frame when mounting or suspending. For doing so release the air/remove the coil, install the shock and compress the shock completely. If the shock touches the frame while doing so, do not use this shock in order to avoid damage to frame, swingarm or shock FRONT FORK SET-UP/ CHANGE OF FRONT FORK For the set up of the front fork please use the fork specific manual attached to the bike. VOLTAGE FR 13 ENGLISH We recommend using front forks with distance of 525mm to 571mm between mid of axle to top of crown, as this will not influence the geometry and alter handling of the bike. PIVOT MAINTENANCE The pivots and bearings on SCOTT Voltage FR are extremely easy to maintain. An external treatment with a grease spray after every bike wash is all you have to do. We do not recommend heavy grease sprays since these will leave a film on the parts which is difficult to remove. We recommend the same for the chain also. [. . . ] A complete list of all parts of wear and tear can be found in the next chapter of this manual. In addition, you will find at the end of this manual a protocol for the handing over of the bike which will remain in copy at the SCOTT dealer after acceptance and signature of the consumer. [. . . ]