User manual SEAGATE FIREBALL PLUS LM JUMPER SETTINGS

[. . . ] Fireball Plus LM Jumper Settings Jumper Settings DS Stand Alone (Default) Master with Slave Present Slave to Master Cable Select * ON ON OFF OFF CS OFF OFF OFF ON PK X X X X Rsvd OFF OFF OFF OFF X= PK is a Parking position. [. . . ] For Ultra ATA/66 compliant cables (80 conductor), the master drive is placed on the outside (end) cable connector and the slave drive is placed on the intermediate cable connector. 1 of 1 Fireball Plus LM fireball_plus_lm_jumper. pdf Jumper Locations The Maxtor® FireballTM Plus LM disk drive has only one location where user configurable jumpers are found. The jumper block is incorporated into the ATA / IDE cable connector. Using the jumper pins you can establish the drive Master/Slave configuration. BIOS Settings The following BIOS parameters are provided for customers needing to manually configure the Fireball Plus LM disk drive. Both base 2 and base 10 capacity values are displayed. 10. 2 GB Logical Cylinders Logical Heads Logical Sectors/Track Total Logical Sectors Base 10 Capacity Base 2 Capacity 16, 383* 16* 63* 20, 066, 251 10, 273MB 9, 797MB 15. 0 GB 16, 383 * 16* 63* 29, 336, 832 15, 020MB 14, 324MB 20. 5 GB 16, 383 * 16* 63* 40, 132, 503 20, 547MB 30. 0 GB 16, 383 * 16* 63* 58, 633, 344 30, 020MB 19, 595MB 28, 629MB *Note: Default Logical Cylinder, Head, and Sector (CHS) values are limited to 16, 383/16/63 respectively per the ATA-4 specification. ATA (IDE) disk drives with capacities greater than 8. 4GB require LBA support from the system BIOS. Check with your system manufacturer to determine if your BIOS supports LBA mode for ATA hard drives greater than 8. 4GB. Drive capacity may be restricted to 8. 4GB (8, 455MB) due to system BIOS CHS limitations. 2 of 2 Fireball Plus LM fireball_plus_lm_jumper. pdf Special Considerations Hard drives greater than 2. 1GB may need to be divided into multiple partitions / logical drives. MS-DOS versions 4. 0 through 6. 22 allow a maximum primary partition / logical drive size of 2. 1GB and are limited to 8. 4GB in physical drive capacity. [. . . ] The Ultra ATA cables use the Cable Select (CS) method rather than a master/slave scheme, so the drive must be configured to enable Cable Select (jumper installed on CS position). For Further Review: · · · · · · · · · · ATA Configuration Card (Includes Drive Mounting) ATA Installation Flowchart ATA Installation Guide for Windows NT ATA Installation Guide for Windows95/98 BIOS Support for logical cylinder values > 4095 DOS/Windows 95 logical drive limitations Knowledge Base Ultra ATA/66 Bus Interface Ultra ATA/66 Compatibility with Award BIOS Windows NT 4. 0 Capacity Issue 3 of 3 [. . . ]