User manual SEGA CLUB KART EUROPEAN

[. . . ] Be sure to keep this manual nearby the product or elsewhere convenient for referring to it when necessary. Herein, explanations which require special attention are enclosed with dual lines. Depending on the potentially hazardous degrees, the terms of WARNING, CAUTION, etc. Be sure to understand the contents of the displays before reading the text. [. . . ] Card setting is enabled with power either on or off. · Unlock and open the cover to find the card reader/writer. The dispenser on which you should place the cards is located at the rear of the reader/writer. · From the card reader/writer, take out the dispenser upward in a straight line. · Remove the cover from the back of the dispenser. · Place the cards into the dispenser according to the instructions on the sticker annexed to the dispenser. There is no print face on a card of the Club Kart. Determine the card in reference to the inserting direction mark located at corners of the cards. Do not confuse the top/bottom or direction. · Reinstall the cover to the dispenser. · Insert the dispenser into the card reader/writer. The dispenser can be inserted only in the predetermined orientation. With the top cover closed, release the green shaft. Check that the top cover has been locked securely. Forcible Cleaning This product memorizes the count you use the card reader/writer. When the power is turned off and on after the count of use exceeds 100, the head cleaning mode is entered while the Check Card Reader/Writer Screen is on-screen after you turn on the power. The head cleaning mode cannot be quitted for being ready for starting the game unless the head cleaning is completed. When the card reader/writer is subjected to head cleaning, the count of use is cleared and the the mode ends. At this time, using a dedicated cleaning card, use the cleaning card procedure according to the instructions on the screen. The count of use above is cleared also when the Test Mode is used for head cleaning. Cleaning Card Reader/Writer Screen CARD R/W CLEANING PLEASE INSERT CLEANING CARD · Insert the cleaning card into the slot. You cannot proceed to the next step until you take it out. 55 www. seuservice. com D. REWRITING DATA ONTO THE CARD The game board of this product backs up the data only when the card reader/writer detects a trouble DURING OPERATION and the Error Screen displays. However, no written data is backed up in the following case: · An action deemed to be illegal was detected while the game or write was in operation. If backed up data remains when the power is turned on the Check Card Reader/Writer Screen will be replaced with the Save Data screen. [. . . ] SRT-2151 509-5838-Y 509-5495-05 600-7008-079 DESCRIPTION SW PLATE SW PB LW1L-15Y-TK1670 PUSH BUTTON BLUE WIRE HARN BUTTON 137 www. seuservice. com 16 ASSY CTRL SHAFT 7 101 2 102 2 103 2 4 5 1 2 6 8 104 4 105 4 3 ITEM NO. 1 2 3 4 5 6 7 8 101 102 103 104 105 PART NO. 999-1291 NCR-2005 111-1131 DUT-2106 DUT-2105 NCR-2003 100-5240 100-5377 030-001435 060-S01400 060-F01400 060-F00800 030-000820-S DESCRIPTION STEERING BASE CKT STEERING SHAFT COUPLING MJT-40K-BL 16-20 (FRI) STOPPER RUBBER STOPPER BOLT M10 BEARING HOLDER BEARING FA130 BEARING 30 M14 X 35 HEX BOLT SPR WASHER M14 FIT WASHER M14 M8 FIT WASHER M8 X 20 HEX BOLT W/S www. seuservice. com 138 17 STEERING MOTOR UNIT (NCR-2100) 139 SCREW FASTENING TORQUE TO BE M3 X 0. 76 N·m M4 X 1. 8 N·m M6 X 5. 8 N·m M8 X 18 N·m GREASING (D-1/2) www. seuservice. com 17 STEERING MOTOR UNIT (NCR-2100) ITEM NO. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 101 102 103 104 105 106 107 108 109 110 201 202 203 204 205 206 207 208 209 210 211 212 301 PART NO. [. . . ]