User manual SEGA LOST WORLD UR

[. . . ] This certifies that the Printed Circuit Boards, Power Supplies and Monitor are to be free of defects in workmanship or materials under normal operating conditions. This also certifies that all Interactive Control Assemblies are to be free from defects in workmanship and materials under normal operating conditions. [. . . ] This also certifies that all Interactive Control Assemblies are to be free from defects in workmanship and materials under normal operating conditions. No other product in this machine is hereby covered. Sellers sole liability in thew event a warranted part described above fails shall be, at it's option, to replace or repair the defective part during the warranty period. For Warranty claims, contact your SEGA distributer. Should the Seller determine, by inspection that the product was caused by Accident, Misuse, Neglect, Alteration, Improper Repair, Installation or Testing, the warranty offered will be null and void. Under no circumstances is the Seller responsible for any loss of profits, loss of use, or other damages. JPT-2030 COP-2005 125-5124 253-5404-01 253-5405-01 253-5406-01 999-0675 280-5124-03 509-5080 000-P00308-0B 012-P00308 FAS-000015 FAS-500006 060-F00300 DESCRIPTION SENSOR UNIT STOPPER PIN TORSION SPRING COVER LEFT BLUE COVER RIGHT BLUE TRIGGER BLUE PROTECT TUBE W/WIRE; COUPLING; WASHER NYLON CLAMP NK03 SW MICRO TYPE M SCR PH BLK M3 X8 TAP SCR#2 PH 3 X8 M SCR PH BLK M3X8 CAP NUT TYPE 3 BLK M3 FLT WSHR M3 OPTIONAL DOLLAR BILL ACCEPTOR THE COIN DOOR ASSEMBLY USED ON LOST WORLD UR UR U/R COMES EQUIPPED TO ACCEPT A DOLLAR BILL ACCEPTOR. ALL NEEDED WIRING CONNECTIONS ARE CONVIENENTLY LOCATED INSIDE THE GAME FOR THIS APPLICATION. THE COIN DOOR CAN ACCCOMMODATE THE FOLLOWING VALIDATORS: HOLE POSITION#1 (FORWARD-MOST POSITION) HOLE POSITION#2 Mars 2000 series Mars 2000 series DBV45 (JCM) CURRENTLY NOT USED DSI01* HOLE POSITION #3 HOLE POSITION #4 *The back flange on the chute can be removed for hold position #4. If the flange is not removed, it may interfere with the back of the cabinent. The frame and cashbox enclosure on this coindoor has been modified to accomodate a Mars 2000 series upstacker. A 2000 series stacker can be added by simply removing the top two entry door and replacing it with a one entry door with a cut-out for a stacker. This one entry door can be ordered through Coin Controls or one of Coin Controls autherized distributors. [. . . ] If the flange is not removed, it may interfere with the back of the cabinent. The frame and cashbox enclosure on this coindoor has been modified to accomodate a Mars 2000 series upstacker. A 2000 series stacker can be added by simply removing the top two entry door and replacing it with a one entry door with a cut-out for a stacker. [. . . ]