User manual SEGA VIRTUA STRIKER 4 SERVICE MANUAL

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual SEGA VIRTUA STRIKER 4. We hope that this SEGA VIRTUA STRIKER 4 user guide will be useful to you.

Lastmanuals help download the user guide SEGA VIRTUA STRIKER 4.


Mode d'emploi SEGA VIRTUA STRIKER 4
Download

You may also download the following manuals related to this product:

   SEGA VIRTUA STRIKER 4 (4191 ko)

Manual abstract: user guide SEGA VIRTUA STRIKER 4SERVICE MANUAL

Detailed instructions for use are in the User's Guide.

[. . . ] Indicates a "Protective Earth Terminal. " Before operating the equipment, be sure to connect it to the Ground. (The step may be omitted for products in which a power cord with earth is used. ) Perform work in accordance with the instructions herein stated. Instructions for work are explained by paying attention to the aspect of accident prevention. Failing to perform work as per the instructions can cause accidents. [. . . ] Install and operate the product in places where appropriate lighting is available, allowing warning labels to be clearly read. To ensure safety for the customers, labels and printed instructions describing potentially hazardous situations are applied to places where accidents can be caused. Ensure that where the product is operated has sufficient lighting allowing the warnings to be read. If any label is peeled off, apply it again immediately. Please place an order with where the product was purchased from or the office herein stated. When handling the monitor, be very careful. (Applies only to the product with a monitor. ) Some of the monitor (TV) parts are subject to high tension voltage. Even after turning off the power, some portions are still subject to high tension voltage sometimes. Monitor repair and replacement should be performed only by those technical personnel who have knowledge of electricity and technical expertise. Be sure to adjust the monitor/projector properly. (Applies only to the product with a monitor/projector. ) Do not operate the product leaving on-screen flickering or blurring as it is. Using the product with the monitor/projector not properly adjusted may cause dizziness or a headache to an operator, a player, or the customers. When transporting or reselling this product, be sure to attach this manual to the product. In the case where commercially available monitors and printers are used in this product, only the contents relating to this product are explained herein. Some commercially available equipment has functions and reactions not stated in this manual. Read this manual together with the specific Instruction Manual of such equipment. * Descriptions herein contained may be subject to improvement changes without notice. * The contents described herein are fully prepared with due care. However, should any question arise or errors be found, please contact SEGA. INSPECTIONS IMMEDIATELY AFTER TRANSPORTING THE PRODUCT TO THE LOCATION Normally, at the time of shipment, SEGA products are in a status allowing for usage immediately after transporting to the location. Nevertheless, an irregular situation may occur during transportation. Before turning on the power, check the following points to ensure that the product has been transported in a satisfactory status. Are there any dented portions or defects (cuts, etc. ) on the external surfaces of the cabinet? [. . . ] Once the number of matches that the suspension corresponds to is over, the accumulated cards are cleared and the player can play in the next match. * A match against the COM where another player joins midway through does not count as one match. * You can skip to the start of the second half by pressing any button other than the Start Button. * You can cancel a selection using the red button. * You cannot select players that were sent off during the first half or players that are under suspension. * If the card is only half-inserted into the card reader/writer, the machine won't detect the card and the game will continue as if a card is not being used. * If you insert the card on the SELECT TEAM screen on the second or subsequent time you play, the team will be selected automatically. * Card renewal can be performed even for cards that have not been fully used up. 5. TEST MODE SYSTEM MENU RAM TEST MEDIA BOARD TEST SYSTEM INFORMATION JVS TEST SOUND TEST C. R. T. TEST . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE SEGA VIRTUA STRIKER 4

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual SEGA VIRTUA STRIKER 4 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag