User manual SEIKO 6R20 AUTOMATIC

[. . . ] 6R20 INSTRUCTIONS BEDIENUNGSANLEITUNG INSTRUCTIONS ISTRUZIONI INSTRUCCIONES INSTRUÇÕES (P. 3) (S. 113) (135 ) English 2 You are now the proud owner of a SEIKO Automatic Watch Cal. To ensure its optimum performance, please read the instructions in this booklet carefully before using it. Please keep this manual handy for ready reference. [. . . ] The watch is provided with a day and date function and is so designed that the day and date changes once every 24 hours. The date changes around 12 o'clock midnight, and the day around 2:00 a. m. If AM/PM is not properly set, the date will change around 12 o'clock noon, and the day around 2:00 p. m. 1. (The second hand continues moving and the accuracy of the watch is unimpaired. ) 2. The day can be set by turning the crown clockwise. The date can be set by turning the crown counterclockwise. Turn it until the previous day's date appears. Ex. ) If today is the 6th of the month, first set the date to "5" by turning the crown counterclockwise. CAUTION · Do not set the date between 10:00 p. m. If you do, the date may not change properly / it may cause a malfunction. Pull out the crown to the second click when the second hand is at the 12 o'clock position. (The second hand stops on the spot. ) Turn the crown to advance the hands until the date changes to the next. Advance the hands to set the correct time. Push the crown back in to the normal position in accordance with a time signal. English CAUTION · The mechanism of mechanical watches is different from that of quartz watches. When setting the time, be sure to turn back the minute hand a little behind the desired time and then advance it to the exact time. 10 Date adjustment at the beginning of the month English It is necessary to adjust the date on the first day after a month that has less than 31 days. period on the first day of a month following a 30-day month. The watch displays "31" instead of "1". Turn the crown to set the date to "1" and then push the crown back into the normal position. CAUTION · Do not set the date between 10:00 p. m. If you do, the date may not change properly / it may cause a malfunction. 11 HOW TO READ THE POWER RESERVE INDICATOR English · · The power reserve indicator lets you know the winding state of the mainspring. Before removing the watch from your wrist, observe the power reserve indicator to check if the watch has enough power stored to keep running until the next time you wear it. (To prevent the watch from stopping, wind the mainspring to store the excess power that will allow the watch to run for extra time. ) Power Reserve Indicator The winding state of the mainspring The number of hours the watch can run Fully wound Approximately 45 hours 1/3 wound Approximately 15 hours Unwound The watch either stops or is running down. 12 * * When the mainspring is fully wound, the crown can be turned further without damaging the mainspring itself. The mainspring of the watch employs a slipping mechanism to prevent the mainspring from over-winding. [. . . ] If the watch does not start, consult the retailer from whom the watch was purchased. Wear the watch for an extended period of time, or when taking off the watch, turn the crown to wind the mainspring if the remaining power shown by the power reserve indicator is not sufficient for the next use. Normal accuracy will resume when the watch returns to normal temperature. Normal accuracy will resume when the watch is kept away from close contact with the magnetic source. If this condition persists, consult the retailer from whom the watch was purchased. [. . . ]