User manual SEIKO H801

[. . . ] H601 / H801 ALARM CHRONOGRAPH INSTRUCTIONS (P. ) INSTRUÇÕES INSTRUCCIONES (P. H601, H801 INSTRUCTIONS INSTRUCTIONS INSTRUCCIONES BEDIENUNGSANLEITUNG ISTRUZIONI INSTRUÇÕES (P. 114) (136 ) You are now the proud owner of a SEIKO Duo-Display Watch Cal. [. . . ] * If the crown is of the screw lock type, unscrew the crown by turning it counterclockwise, and then pull it out. Turn the crown to set the desired hour and minutes. When setting the minute hand, advance it a few minutes ahead and then turn it back to the exact time. Push the crown back in to the normal position in accordance with a time signal. * * If the crown is of the screw lock type, screw it in completely by turning it clockwise while pressing it. ALARM AND HOURLY TIME SIGNAL Alarm set display mark Alarm mark 3. * If "A" is kept pressed, the digits advance quickly. Press "B" to return to the ALARM display. * If the watch is left untouched in the ALARM display or with digits flashing, the display will automatically return to the CALENDAR display after 1 to 2 minutes. Note: Check that AM/PM is set properly in the 12-hour indication. For the AM setting, there is no indication. Hourly time signal mark Hour Alarm time setting 1. Press "A" to show the ALARM display, and then press "B" to activate the ALARM SETTING function. Press "B" repeatedly to select the digits to be adjusted in the following order. ALARM DISPLAY A Minutes Alarm and hourly time signal engagement B With each press of both "A" and "B" in the CALENDAR or TIME display, the alarm and hourly time signal marks appear and disappear in the following order. B HOUR MINUTES A Alarm 1 2 3 4 Hourly time signal Both engaged Hourly time signal engaged Alarm engaged Neither engaged STOPWATCH Press "A" to show the STOPWATCH display. The stopwatch can measure up to 60 minutes. After 60 minutes, it will start counting again from "00'00"oo". · Before use, be sure to press "B" to reset the digits to "00'00"oo". * The alarm can be tested by pressing "A" and "B" at the same time for several seconds. To stop it manually, press "A" or "B". B Minutes Seconds 1/100 second Standard measurement To start To stop To reset : : : Press "B" Press "B" Press "B" A Note: When measuring a long period of time, press "A" to return the STOPWATCH to the CALENDAR or TIME display after the stopwatch starts. This will prevent any possible mistaken operation. First, press button A to show stopwatch display. Set "60" on the rotating bezel to the 12 o'clock position. The tachymeter can be used for the following purpose. (1) To measure the hourly average speed of a vehicle with the stopwatch display to determine how many seconds it takes to go one kilometer (or mile). 1) HOW TO USE THE TACHYMETER (For those models which include a tachymeter with a graduated dial) B Note: Some models have a dial with 12 graduations. [. . . ] s PERIODIC CHECK It is recommended that the watch be checked once every 2 to 3 years. Have your watch checked by an AUTHORIZED SEIKO DEALER or SERVICE CENTER to ensure that the case, crown, buttons, gasket and crystal seal remain intact. s LIQUID CRYSTAL PANEL The normal life expectancy for a liquid crystal panel is approximately 7 years. After that it may decrease in contrast, becoming difficult to read. [. . . ]