User manual SENNHEISER EK 1013-6

[. . . ] 35 SKP 100 G2 / SKP 500 G2 plug-on transmitters . 37 LC display panel of the evolution wireless transmitters G 2 . 39 The operating menu of the transmitters evolution wireless series G 2 41 Overview of menus . 42 Overview of the operating menu of the transmitters . [. . . ] Some furniture surfaces have been treated with varnish, polish or synthetics which might cause stains when they come into contact with other synthetics. Despite a thorough testing of the synthetics used by us, we cannot rule out the possibility of staining. Do not place the receiver on delicate surfaces. Switching the charger on or off To switch the charger on, insert the hollow jack plug on the cable of the mains unit (mains unit must be ordered separately) into socket ². All LEDs briefly light up one after the other. ² 24 L 2015 quick charger Using the charger Charging the rechargeable battery BA 2015 µ » Insert the rechargeable battery µ into one of the two charging compartments » as shown. The red LED ³ at the occupied charging compartment lights up. Charging a completely discharged rechargeable battery takes approx. It is normal for the accupacks to get warm during charging. However, the charging process may take longer if: the rechargeable battery is deep-discharged and first has to be reconditioned by a deep discharge recovery charge, the ambient temperature is close to or over 40 °C, since, in order to protect the accupack, the charging process will be interrupted until the rechargeable battery temperature has fallen to an admissible value. For safety reasons, the charging process will be interrupted and the red LED ³ will start flashing if: excessively hot accupacks cannot cool down, an rechargeable battery cannot be fully charged within the max. After the rechargeable battery has been fully charged, the green LED · lights up. The battery status indications on the displays, the transmission of transmitter battery status information to the rack-mount receivers and the switch-off thresholds at the end of the operating time are corrected correspondingly. Due to the missing sensor, individual rechargeable battery cells will not be identified as accupacks. The monitoring of the rechargeable battery temperature during charging in the L 2015 charger. Changing the microphone module First remove the battery or the rechargeable battery and leave the radiomicrophone open. Unscrew the sound inlet basket. 29 SKM 100 G2 / SKM 300 G2 / SKM 500 G2 radiomicrophones Remove the screw and put it to one side. Remove the microphone module by pulling it out of the housing as shown. Secure the capsule by tightening the screw. Note: The screw mechanically secures the microphone capsule. If the screw is missing, malfunctions may occur during tough use. Put on the sound inlet basket and identification ring supplied with the new microphone headand screw it tight. Close the radiomicrophone and put it into operation. [. . . ] Warranty claims can be enforced in any country throughout the world in which the statutory rights of the country concerned are not in conflict with our warranty regulations. No other warranty claims or claims over and above the rights stated in these terms and conditions will be accepted. Consumers may be entitled to statutory rights in their own countries which are not restricted by these warranty terms and conditions, as the warranty is governed by the laws of the country in which the Sennheiser product was purchased by the consumer. The provisions of the UN Convention on the International Sale of Goods do not apply to this service. [. . . ]