User manual SENNHEISER EW 300 IEM G3

[. . . ] 300 IEM Series Instruction manual Contents Contents Important safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 The evolution wireless series ew 300 IEM G3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 The frequency bank system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 5 5 6 7 8 Putting the devices into operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The transmitter switches on and the standard display appears. The transmitter transmits an RF signal and the transmission icon is displayed. To switch the transmitter on and to deactivate the RF signal on switch-on (offline operation): Press the STANDBY button ¶ until "RF Mute On?" appears on the display panel. The transmission frequency is displayed but the transmitter does not transmit an RF signal. In addition, the display backlighting changes from orange to red and "RF Mute" flashes in alternation with the standard display. Use this function to prepare a transmitter for use during live operation without causing interference to existing transmission links. To activate the RF signal: Briefly press the STANDBY button ¶. "RF Mute Off" appears on the display panel. The transmission icon is displayed again. To switch the transmitter to standby mode: If necessary, deactivate the lock mode (see page 18). Keep the STANDBY button ¶ pressed until "OFF" appears on the display panel. The transmitter switches to standby mode. 16 Using the devices When in the operating menu, pressing the STANDBY button ¶ will cancel your entry (ESC function) and return you to the standard display. The STANDBY button ¶ is backlit in red both during operation and in standby mode. To completely switch the transmitter off: Disconnect the transmitter from the mains by unplugging the mains unit from the wall socket. The backlighting of the STANDBY button ¶ goes off. Switching the EK 300 IEM G3 diversity receiver on/off To switch the diversity receiver on: Turn the volume control ³ clockwise until it clicks. The "Frequency/Name" standard display appears on the display panel. To switch the diversity receiver off: Turn the volume control ³ counterclockwise until it clicks. The red ON LED ¿ goes off and the diversity receiver switches off. Monitoring the audio signal via headphones CAUTION!Listening at high volume levels for long periods can lead to permanent hearing defects. Set the volume control to the minimum position before putting the headphones on. Do not continuously expose yourself to high volumes. To monitor the audio signal via the headphone output of the diversity receiver: Connect earphones with a 3. 5 mm stereo jack plug to the headphone output ·. When switching the receiver on, slowly and carefully turn the volume control ³ clockwise. Via the receiver's operating menu (see page 24), adjust: ­ stereo or Focus operation ("Mode" menu item) ­ the balance ("Balance" menu item) ­ the treble boost ("High Boost" menu item) ­ the limiter ("Limiter" menu item) · The ground connection of the earphones cable serves as the second antenna for adaptive diversity operation. To monitor the audio signal via the headphone output of the transmitter: Set the headphone volume control · to the minimum position. Stereo Transmitter Connect headphones with a ¼" (6. 3 mm) stereo jack plug to the headphone output ³. Gradually increase the volume and monitor the audio signal with the lowest possible volume. ³ · 17 Using the devices Selecting a standard display on the diversity receiver ESC Press the ESC button to select a standard display. In stereo mode, you can alternatively press the rocker button. Selectable standard display "Frequency/Name" with "Mute" display Contents of the display 519. 150 MHz ew300 IEM RF AF P MUTE B. CH 1. 1 Lim: - 6dB RF AF P "Frequency/Limiter" with display of the audio channels (Stereo/Focus) 519. 150 MHz EQ RF AF P "Frequency/High Boost" with display of the audio channels (Stereo/Focus) For more detailed information, refer to the chapter "Overview of the displays of the EK 300 IEM G3 diversity receiver" on page 8. Deactivating the lock mode temporarily You can activate or deactivate the automatic lock mode via the "Auto Lock" menu item. If the lock mode is activated, you have to temporarily deactivate it In order to be able to operate the devices: SR 300 IEM G3 transmitter Press the jog dial. "Locked" appears on the display panel. [. . . ] 70 dB 80 dB Off, 5 to 25 dBV, adjustable in steps of 2 dB can be switched off approx. 90 dB 2 x 100 mW at 32 +8 dB at 10 kHz ­18 dB to ­6 dB, adjustable in steps of 6 dB, can be switched off 2 AA size batteries, 1. 5 V or BA 2015 accupack 2. 4 V approx. 4 to 6 hrs (depending on volume level) approx. 200 g In compliance with Europe EMC Radio USA EN 301489-1/-9 EN 300422-1/-2 Safety EN 60065 47 CFR 15 subpart B 32 If a problem occurs . . . Approved by Canada Industry Canada RSS 123 IC 2099A-G3SREK300 limited to 806 MHz Connector assignment SR 300 IEM G3 transmitter ¼'' (6. 3 mm) stereo jack plug, balanced (BAL AF IN/LOOP OUT) XLR-3F connector, balanced (BAL AF IN) + 2 3 1 DC connector for power supply ¼'' (6. 3 mm) mono jack plug, unbalanced ¼'' (6. 3 mm) stereo jack plug for headphone output EK 300 IEM G3 receiver 3. 5 mm jack plug LR Accessories The following EK 300 IEM G3 accessories are available from your specialist dealer: 009950 009828 500432 503166 503167 503158 503873 503874 004645 003658 002324 002325 BA 2015 accupack L 2015 charger IE 4 earphones AC 3 antenna combiner GA 3 rack adapter NT 3-1 EU: Power supply for powering the AC 3 antenna combine and four transmitters, EU version NT 3-1 US: Power supply for powering the AC 3 antenna combine and four transmitters, 120 V version NT 3-1 UK: Power supply for powering the AC 3 antenna combine and four transmitters, UK version A 1031 omni-directional broadband antenna A 2003 directional broadband antenna GZL 1019-A1 coaxial cable, type RG 58, BNC to BNC, 1 m GZL 1019-A1 coaxial cable, type RG 58, BNC to BNC, 5 m The following SR 300 IEM G3 accessories are available from your specialist dealer: 33 Manufacturer Declarations Manufacturer Declarations Warranty Sennheiser electronic GmbH & Co. [. . . ]