User manual SENNHEISER GZN 10

[. . . ] 6 Receiver . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Transmitter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 LED indications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Connection possibilities . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] For information on suppliers, contact your local Sennheiser partner: www. sennheiser. com > "Service & Support" RS 4200 II | 5 Operating controls Operating controls The overview pictures of the receiver and the transmitter can be found on the inside front cover of this instruction manual. A Receiver 1 2 3 4 Volume control Compartment for BA 300 rechargeable battery Balance control TUNE button B Transmitter 5 3. 5 mm stereo jack socket labeled AUDIO (marked blue) for connection of sound source 6 Channel selector switch CHANNEL 7 DC socket labeled 9 VDC (marked yellow) for connection of mains unit 8 "Speech intelligibility" button 9 Antenna 0 Charging compartment for receiver A Charging compartment for spare rechargeable battery B LED indications B Charging control LED for spare rechargeable battery C Charging control LED for receiver rechargeable battery D Operation indication C Connection possibilities E F G H I Connection cable for headphone socket Adapter to 1/4" (6. 3 mm) jack socket Adapter (RCA/jack socket) SCART adapter (optional) Mains unit 6 | RS 4200 II Putting the system into operation Putting the system into operation Setting up the transmitter Choose a suitable place near your sound source (e. g. Do not place the transmitter close to metal objects such as shelf bars, reinforced concrete walls, etc. as this can decrease the transmitter's range. It is not necessary that the transmitter and stethoset receiver are in a direct line of sight, so you can move around freely in the home or outside in the garden. One transmitter can be used to transmit to several receivers on the same frequency. Connecting the transmitter to the sound source Plug in one end of the connection cable E to the blue AUDIO socket 5 on the transmitter. Check the connection possibilities of your sound source (e. g. TV). A B C R A D No socket TV L Headphone socket TV RCA sockets AV SCART socket External microphone RS 4200 II | 7 Putting the system into operation A hea Connecting the transmitter via the headphone socket Plug in the other end of the connection cable E to the headphone socket on your sound source. Adjust the volume of the headphone socket on your sound source to a medium level. This improves the quality of wireless sound transmission. If necessary, check the menu setting of your TV. With most TVs, the headphone socket is located at the front or sides. green: The rechargeable battery is fully charged. B A Replacing the ear pads The product is supplied with two pairs of ear pads in different fits. You can change to these ear pads to optimize the wearing comfort, if necessary (see "Cleaning the ear pads" on page 15). 10 | RS 4200 II Using the system components Using the system components Switching the transmitter on/off To switch the transmitter on: Switch your sound source on. This automatically switches on the transmitter and the LED D lights up green. If the transmitter does not switch on, increase the volume of your sound source. To switch the transmitter off: Switch your sound source off. The transmitter automatically switches off after 3 minutes. In order to save energy, you can manually switch off the transmitter even if the sound source remains switched on. To do so, keep the button 8 pressed until the LED D goes off. In this case, the rechargeable batteries can still be charged. To switch the transmitter on again, briefly press the button 8, the LED D lights up. Switching the stethoset receiver on WARNING Danger of hearing damage!Listening at high volume levels for long periods can lead to permanent hearing defects. [. . . ] Dry the ear pads before putting them back on the receiver. 0 RS 4200 II | 15 If a problem occurs. . . If a problem occurs. . . Check if the problem you face is listed in the table below: Problem Possible cause Page 7 ff 7 ff 9 11 11 12 10 You cannot hear Are all jack plugs connected anything correctly?Is the transmitter connected to the sound source?Is the transmitter connected to the mains?Is the volume of the sound source sufficient? [. . . ]