User manual SENNHEISER RS 160

[. . . ] Digital Wireless System Instruction manual RS 160 Contents Contents Important safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 The RS 160 digital RF headphone system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Delivery includes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Product overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Charge the rechargeable batteries for at least 16 hours prior to first time use. Subsequent charging time is about half of the previous operating time. Connect the charging cable Connect the charging cable unit. to the charging socket ¶ on the to the socket to the connector on the transmitter. of the power supply 16h Plug the power supply unit into a wall socket. The rechargeable batteries are being charged. The multi-function LED º on the headphones lights up orange. 7 º ¶ 9 0 3 The transmitter automatically switches from battery operation to mains operation if you connect the power supply unit or the charging cable to the transmitter. 16 Putting the RS 160 into operation Adjusting the headband of the headphones ³ For good sound quality and best possible comfort, the headband has to be adjusted to properly fit your head. To do so, adjust the headband ³ via its snap-in locking mechanism: HDR 160 Wear the headphones so that the headband ³ runs over the top of your head. Adjust the length of the headband so that ­ your ears are completely inside the earpads, ­ you feel even, gentle pressure around your ears, ­ a snug fit of the headband ³ on the head is ensured. 17 Using the RS 160 Using the RS 160 To switch the product on and to listen to your sound source, proceed as follows: Sequence of steps 1. Make sure that the rechargeable batteries are charged. Page 16 ­ 18 20 21 Switching the transmitter on and off Switching the transmitter on Press the multi-function button for approx. The multi-function LED flashes green, indicating that the transmitter is in enrollment mode. Once the transmitter has found suitable headphones, it pairs with the headphones and transmits an audio signal. The multi-function LED º of the headphones and the multi-function LED of the transmitter flash slowly. 1s 5s º 1 2 18 Using the RS 160 Switching the transmitter off Press the multi-function button for approx. To disconnect the transmitter from the mains: Pull out the mains plug from the wall socket. If the headphones are outside the transmission range or switched off for more than 5 minutes, the transmitter automatically switches to standby mode. In standby mode, the transmitter's power consumption is very low so that it can remain connected to the mains. 19 Using the RS 160 Switching the headphones on and off WARNING Danger due to high volumes!Listening at high volume levels for long periods can lead to permanent hearing defects. Before putting the headphones on, set the volume to a low level. Do not continuously expose yourself to high volumes. Switching the headphones on Press the multi-function button ´ for approx. The multi-function LED º flashes green, indicating that the headphones are in enrollment mode. [. . . ] WEEE Declaration Your Sennheiser product was developed and manufactured with highquality materials and components which can be recycled and/or reused. This symbol indicates that electrical and electronic equipment must be disposed of separately from normal waste at the end of its operational lifetime. Please dispose of this product by taking it to your local collection point or recycling centre for such equipment. This will help to protect the environment in which we all live. 32 Manufacturer declarations Statements regarding FCC and Industry Canada FCC Declaration of Conformity (DoC) SENNHEISER Model No: RS 160 We, Sennheiser Electronic Corporation Strat. [. . . ]