User manual SENNHEISER SI 1015-12500 DUAL PRODUCT SHEET

[. . . ] The NT1015-120 will provide power for the SI1015 modulaRatchet Adjustment tor and up to two SZI1015 or SZI1029 emitters. The SZA1060 terminating resistor 5/8" External For Angle (50 ohm), for the last emitter in a daisy chain, is included for system designs that Thread RF Output (BNC) incorporate daisy chaining of emitters. The GA1031-CC rack adapter allows for MONO/Multi Switch IEC Mains Connector easy mounting of a SI1015 modulator to a 19" rack. [. . . ] The SI1015 modulator must utilize the higher sub-carrier frequencies of 2. 3 and 2. 8 MHz for single, two channel or stereo operation with an AF frequency response of 50-15, 000 Hz. It must be rack-mountable and have two monitoring diodes for the technician. It must accept line level audio input via XLR connector. It must be easy to install using barrier strip with RF and DC outputs for connecting to emitters; and, alternatively, BNC connectors for connecting the RF signal only. It must have AF level controls with LED's indicating peak volumes. The power supply NT1015-120 shall provide power for one SI1015 emitter and shall have an input voltage of 100-240 V (1. 3 A), an output voltage of approx. The GA 1031-CC rack adapter is capable of mounting an individual SI 1015 modulator to a 19" rack. The SI1015, SZI1015 and SZI1029 shall be wall or ceiling mountable via a mounting clamp with 5/8" external male thread, and the mounting plate shall have a diameter of 1 5/8". The stethophone shall be a two channel IR receiver with the following: wideband FM, stereo modulation, 2. 3 and 2. 8 MHz carrier frequencies, 18-18, 000 Hz AF frequency response, greater than 1% THD, typ. 5 hours operating time, and a weight of approx. The stethophone shall be a Sennheiser HDI302. The receivers shall contain a rechargeable Nickel Metal Hydride battery, which can easily be recharged with the L151-10 charging unit for up to ten rechargeable batteries. The NT2013-120 power supply is capable of powering two to five of the L151-10 charging units. The SZI1029 shall be an infrared high power radiator with RF input for wide and narrow-band signals. Carrier frequency band extends to 6 MHz RF input (50 mV to 3V) via BNC socket, RF output via BNC socket. The unit shall offer excellent reliability due to 12 independent diode groups with malfunction indicator. [. . . ] The Sennheiser Service Department will be the sole authority to determine the validity of all warranty issues. This Limited Product Warranty is Sennheiser Electronic Corporation's only warranty, and the customer's only remedy concerning Sennheiser products. All other representations and warranties, express or implied, written or oral, including, but not limited to, any warranties of merchantability, fitness for a particular purpose, or non-infringement, are expressly excluded. [. . . ]