User manual SENNHEISER SI 1015-4000 DUAL PRODUCT SHEET

[. . . ] The NT1015-120 will provide powerAngle the SI1015 modula- 5/8" External mm) For for (126. 24 tor and up to two SZI1015 or SZI1029 emitters. The SZA1060 terminating resistor Thread (50 ohm), for the last emitter in a daisy chain, is included for system designs that incorporate daisy chaining of emitters. The GA1031-CC rack adapter allows forInput Terminals RF RF Output (BNC) Terminals easy mounting of a SI1015 modulator to a 19" rack. [. . . ] The SI1015 modulator must utilize the higher sub-carrier frequencies of 2. 3 and 2. 8 MHz for single, two channel or stereo operation with an AF frequency response of 50-15, 000 Hz. It must be rack-mountable and have two monitoring diodes for the technician. It must accept line level audio input via XLR connector. It must be easy to install using barrier strip with RF and DC outputs for connecting to emitters; and, alternatively, BNC connectors for connecting the RF signal only. It must have AF level controls with LED's indicating peak volumes. The modulator must be capable of remotely powering one or two emitters. The power supply NT1015-120 shall provide power for one SI1015 emitter and up to two SZI1015, and shall have an input voltage of 100-240 V (1. 3 A), an output voltage of approx. The GA 1031-CC rack adapter is capable of mounting an individual SI 1015 modulator to a 19" rack. The SZI1015 emitters shall be wall or ceiling mountable via a mounting clamp with 5/8" external male thread, and the mounting plate shall have a diameter of 1 5/8". The stethophone shall be a two channel IR receiver with the following: wideband FM, stereo modulation, 2. 3 and 2. 8 MHz carrier frequencies, 18-18, 000 Hz AF frequency response, greater than 1% THD, typ. 5 hours operating time, and a weight of approx. The stethophone shall be a Sennheiser HDI302. The receivers shall contain a rechargeable Nickel Metal Hydride battery, which can easily be recharged with the L151-10/NT charging device (with power supply) for up to ten rechargeable batteries. The SZI1015 shall be an infrared emitter with a carrier frequency band that extends to 6 MHz RF input (50 mV to 3V) via BNC socket or barrier strip, RF output via BNC socket or barrier strip. The unit shall offer excellent reliability due to 72 individual diodes. The unit shall offer an operating voltage of 25-30 V DC and weigh approx. [. . . ] The Sennheiser Service Department will be the sole authority to determine the validity of all warranty issues. This Limited Product Warranty is Sennheiser Electronic Corporation's only warranty, and the customer's only remedy concerning Sennheiser products. All other representations and warranties, express or implied, written or oral, including, but not limited to, any warranties of merchantability, fitness for a particular purpose, or non-infringement, are expressly excluded. [. . . ]