User manual SENNHEISER SK 1013-6-1

[. . . ] The Sennheiser Mikroport system consisting of a SK 1013-6-1 and an EK 1013-6-1 offersthe listener direct reception of the spoken word, thus eliminating all influences caused by the acoustical characterstics of the room along with the normal attenuation due to the distance between speaker and listener. The bullt-in "HiDyn" noise reduction system makes fm supreme transmission quality. The SK 1013-6-1 may alternatively be powered by three batteries, types IEC LR 6, or by rechargeable batteries of the same type" Connecting the microphone To the. microphone input connector (1) Sennheiser microphones, types MKE4012 (cardioid) and MKE 2012 (omnidirectional) may be connected. [. . . ] Besides the reduces the input gain if a reaches. :!:. 8 kHz). 82 dB (DIN 45500, curve A, rms) Microphone input (nominal swing) AF-sensitivity Wiring Switch on transmitter and receiver. Make sure that both sets are operating at the same frequency. Speak into the microphone at normal voice. Optimum results have in practice been reached by speaking a long "aaahh" into the microphone. During this level check hold the transmitter in its normal operating position. Listen to the signal at the receiver with a set of headphones while you speak into the microphone. Slowly increase gain until the volume ceases to rise. Now reduce the setting by a quarter-turn. max. 70 mV (limiter threshold) pin 1: AF pin 2 + 3: ground pin 8: DC-voltage supply of electret mifor crophones approx. 26 dB Line input Input impedance AF-sensitivity (nominal swing) Adjustlng range of the level control at Control range oflimiter Fastening neck strap and clip The set is supplied with a neck strap and a clip for fastening the set to the body. The strap must be attached to the slots shown in fig. When fastening it must snap into place with an aud ible cl ick. With the clip the transmitter can be easily attached to the waistband or belt (fig. Since the microphone MKE 2012 and MKE 4012 are not suitable for this kind of application a clip-on microphone, e. MKE 2 R, MKE 10 R or MKE 40 R is to be used instead. [. . . ] 35 mA Power supply 3 x 1. 5 V battery (Mignon IEC LR 6) approx. 10 h with N iCd-accumu lators height: deoth: 100, with helical antenna: 38 185 Dimensions in mm width: 66 Weight (with batteries and microphone) 200 9 We reserve the right to alter specifications, in particular with regard to technical improvements. Hints for operation on rechargeable batteries 6 1. Switch off the transmitter before recharging. [. . . ]