User manual SENNHEISER TOURGUIDE 2020

[. . . ] Tourguide System 2020 Instructions for use Contents Important safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 System components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Overview of the system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 The operating controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Never try to charge other rechargeable batteries or non-rechargeable batteries. Charging the accupack in the bodypack transmitter To charge the bodypack transmitter in the EZL 202020 L charging case: Place the bodypack transmitter with the accupack inserted into the charging compartment for the accupack/bodypack transmitter ³ as shown in the diagram on the left. When placed into a charging compartment, the bodypack transmitter automatically switches off. The red LED CHARGE/ERROR · of the charging compartment lights up. · » When the accupack in the bodypack transmitter is fully charged, the green LED READY » lights up. Notes: Charging a completely discharged accupack takes approx. Alternatively, you can remove the accupack from the bodypack transmitter and insert it into the charging compartment for accupack/bodypack transmitter ³, as described in the following section. In the charging case, there is no error indication like the one on the quick charger L 2015 ("red flashing LED"). 29 Using the components Charging the BA 2015 accupack ³ To charge the accupack of the wireless microphone or bodypack transmitter: Remove the accupack, as described on page 23 or page 24. Place the accupack into the charging compartment for the accupack/bodypack transmitter ³ as shown in the diagram on the left. The red LED CHARGE/ERROR · of the charging compartment lights up. · » When the accupack is fully charged, the green LED READY » lights up. Notes: Charging a completely discharged accupack takes approx. It is normal for the accupacks to get hot during charging. However, the charging process may take longer if: ­ the accupack is deep-discharged and first has to be reconditioned by a deep discharge recovery charge, ­ the ambient temperature is close to or over 40°C, since, in order to protect the accupack, the charging process will be interrupted until the temperature has dropped to a safe level. For safety reasons, each charging process will be interrupted after 4 hours. When not using the BA 2015 accupack for extended periods of time, charge it about every three to six months. 30 Using the components Charging the receivers' built-in rechargeable batteries Place the receiver into one of the charging compartments for receivers ´/µ (light blue in the diagram). The LED · lights up (see table). · LED colour Meaning red green red (flashing) yellow/ orange The built-in rechargeable battery is being charged. The built-in rechargeable battery is fully charged. The temperature of the built-in rechargeable battery is over 40°C or below 3°C The built-in rechargeable battery is defective. Interrupt the charging process and contact your Sennheiser Service. ´ µ Notes: Charging a completely discharged rechargeable battery takes approx. However, the charging process may take longer if: ­ the rechargeable battery is deep discharged and first has to be reconditioned by a deep discharge recovery charge, ­ the temperature of the built-in rechargeable battery is over 40°C or below 3°C, since, in order to protect the rechargeable battery, the charging process will be interrupted until the temperature is again within the admissible range (the LED · flashes red). An additional temperature protection prevents overheating inside the charging case. If the temperature inside the charging case exceeds safety limits, the charging process will be interrupted and will only be restarted when the charging case has cooled down. When not using the receivers for extended periods of time, charge them about every six months in order to prevent deep discharge damage to the rechargeable batteries. [. . . ] To minimise the risk of damage in transit, we recommend that the original packaging is used. CE Declaration of Conformity This equipment is in compliance with the essential requirements and other relevant provisions of the Directives 2004/108/EC, 2006/95/EC and 1999/05/EC. The declaration is available on the Internet at www. sennheiser. com. Before putting the device into operation, please observe the respective country-specific regulations! [. . . ]