User manual SENSORMATIC MV96P

[. . . ] English Multivision® Pro Installation and Operation MV19p, MV16p, MV94p, MV99p, MV96p Part Number 8000-2135-01 REV B Multivision® Pro English Notice The information in this manual was current when published. The manufacturer reserves the right to revise and improve its products. All specifications are therefore subject to change without notice. Under copyright laws, the contents of this manual may not be copied, photocopied, reproduced, translated or reduced to any electronic medium or machine-readable form, in whole or in part, without prior written consent of Sensormatic Video Products Division. [. . . ] ACT HI -- The alarm output signal goes "high" when a motion alarm occurs. NOTE: The duration of the alarm output signal is determined by the Alarm Duration setting. The default ALARM OUTPUT POLARITY setting is ACT LOW. Chapter 4 -- Setup 21 Pass-Thru Extrnl Alrms This menu option lets you loop (pass-thru) the external alarm inputs to the alarm outputs. YES -- Alarm outputs represent all alarms for a particular camera; motion alarms, mechanical alarms and video loss alarms. NO -- Alarm outputs are for motion alarms only. External alarms are not included (not passed-thru). The default PASS-THRU EXTRNL ALRMS setting is YES. Image Tenderizer This option reduces the shakiness and jitter associated with high resolution compressed multicamera images. ON -- Uses the special filtering circuit when the multiplexer displays a multicamera image on the main monitor. OFF -- Turns off the special filtering circuit. The default IMAGE TENDERIZER setting is ON. When finished, press the zoom button to go to menu 4 or press function+zoom to save all changes and leave the setup system. Menu 4 -- VCR Record Time Menu 4 allows you to enter the VCR's normal and alarm recording speeds. With autodetect VCR speed, these settings are used if that signal is lost. Use the up and down arrow buttons to set each speed as follows: VCR RECORD TIME -- The VCR's normal (nonalarm) operating speed (2--999 hours). VCR ALARM RECORD TIME -- The VCR's recording speed for alarms (2--999 hours). The default VCR ALARM RECORD TIME is 002 HRS. NOTE: If the multiplexer alarm output is not connected to the VCR's alarm input, the VCR RECORD TIME and the VCR ALARM RECORD TIME should be set to the same value. When finished, press the zoom button to go to menu 5 or function+zoom to save all changes and leave the setup system. 22 Multivision® Pro Installation and Operation Manual Menu 5 -- Alarm Duration Menu 5 allows you to set the minimum multiplexer alarm time. The ALARM DURATION setting determines how many seconds the multiplexer remains in the alarm state after an alarm event occurs. Set the ALARM DURATION time using the up and down arrow buttons. You may use any setting between 2 and 999 seconds. The default ALARM DURATION setting is 4 seconds. When finished, press the zoom button to go to menu 6 or function+zoom to save all changes and leave the setup system. Menu 6 -- Global Dwell The GLOBAL DWELL setting determines the rate at which the multiplexer sequences cameras on the main monitor (either full screen or in the lower right window) when sequence is selected. [. . . ] Check remote panel power cable connection. No response to remote Serial communications protocol not Configure remote device for 1200 input. bps, 1 start bit, 8 data bits, 1 stop bit, no parity. Appendices 51 APPENDIX D TECHNICAL SPECIFICATIONS Operating Defaults The following specifications apply to Robot multiplexer series products only. Robot reserves the right to revise and improve its products. All specifications are therefore subject to change without notice. [. . . ]