User manual SEVERIN CP 9217

[. . . ] Rating label (on underside of base unit) 2. Power cord storage Important safety instructions Before the appliance is used, the main body as well as any attachment fitted should be checked thoroughly for any defects. Should the appliance, for instance, have been dropped onto a hard surface, it must no longer be used: even invisible damage may have adverse effects on the operational safety of the appliance. [. . . ] The address can be found in the appendix to this manual. Short-time operation The appliance has been designed for shortterm operation only, i. e. it should not be operated continuously for more than 5 minutes. Switch off the appliance afterwards and allow the motor to cool down before switching it on again. Start up Before the juicer is used for the first time, it must be cleaned as described in the section General Cleaning and Care. Operation - Attach the juice container to the drive shaft of the base unit. Turn the container clock-wise until it locks into place. - Fit the small juicing cone onto the pulp sieve; then attach the sieve to the juice - - - container in such a way that the sieve handle is positioned above the container handle. When processing larger citrus fruits such as oranges, the large juicing cone can be fitted over the smaller one. The two recesses in the large juicing cone must be exactly aligned with the two corresponding lateral protrusions on the smaller cone. Insert the plug into a suitable wall socket. Cut the citrus fruit in half and push one of the halves lightly down onto the cone with the cut section facing downwards. The drive shaft will start rotating automatically once pressure is applied to the cone. The appliance switches off when pressure on the cone is lifted. The motor can rotate in either direction and may also change direction during operation. When processing larger quantities of fruit, the pulp sieve must be emptied from time to time as necessary. Always remove the plug from the wall socket before pouring out the juice. [. . . ] To avoid the risk of electric shock, do not clean the base unit or power cord with water, and do not immerse them in water. Do not use abrasives, harsh cleaning solutions or hard brushes for cleaning. - The base unit may be wiped with a slightly damp, lint-free cloth. [. . . ]