User manual SEVERIN KAFFEEAUTOMAT MIT TIMER KA 4031

[. . . ] Do not allow the appliance or its power cord to touch hot surfaces or to come into contact with any heat sources. Caution: the hot-plate becomes very hot during operation. To prevent the danger of hot water or steam being emitted, always switch off the coffee maker and allow sufficient time for the appliance to cool down before it is opened or any accessories or attachments are removed. Once the water container has been filled with water, ensure that the filter and the glass carafe have been correctly fitted to the appliance. [. . . ] The LCD display showsBREW and the time last entered, or 0:00. - While the PROG button is pressed, the desired time can be set using the buttons `H' und `M'. Afterwards, press the On/Off button once. The red indicator light AUTO comes on and the LCD display shows AUTO. At the preprogrammed time, the coffee maker will automatically switch on. 6 On/Off button (I/0) The On/Off button is used to switch between the three settings 0-AUTO-I: 0 - The appliance is switched off. AUTO - The appliance automatically switches on at the preprogrammed time. The red AUTO indicator light comes on and the LCD display shows AUTO. Before using for the first time Before making coffee for the first time, let the appliance go through two or three filtration cycles using the indicated maximum amount of cold water, but without using ground coffee. This should also be done if the appliance has not been used for an extended period of time, and after descaling. General information - A measuring scale on the water container and on the glass carafe facilitates filling the container with the correct amount of clean water. With a dual-scale, the left scale is used for regular-sized cups of approx. 125ml, while the right scale is used for smaller cups. Make sure that the indicated maximum amount of water is not exceeded. If several consecutive brewing cycles are required, switch off the coffee maker after each cycle and let the appliance cool down for approx. Important note: When filling the appliance with fresh water shortly after a brewing cycle is completed, there is a danger of scalding from hot water or steam escaping through the water outlet. Making coffee - Filling with water: Open the water container lid, fill the container with the desired quantity of water and replace the lid. - Inserting the paper filter: Open the swing-out filter sideways and insert a size-4 paper filter into the filter holder, first folding down the perforated sides of the filter. - Filling with ground coffee: For each regular-sized cup (125ml), a measure of about 6 g (= 11/2 - 2 teaspoons) of medium or finely ground coffee will be required. - Preparing the glass carafe: Fit the aroma protection lid onto the carafe, and then place the carafe into the appliance. If correctly inserted, the lid will disable the drip-stop mechanism in the filter holder during the brewing cycle. - Starting the brewing cycle: Press the On/Off button twice to switch on the coffee maker. If the brewing cycle is to be started with a delayed timer setting, press the PROG button to verify that the timer has been set to the desired time. The LCD display shows AUTO, and the red indicator light AUTO comes on. [. . . ] - The glass carafe may be cleaned with warm water after use. Wipe dry afterwards - Both glass carafe and lid are dish-washer safe. Disposal Do not dispose of old or defective appliances in domestic garbage; this should only be done through public collection points. Guarantee This product is guaranteed against defects in materials and workmanship for a period of two years from the date of purchase. [. . . ]