User manual SEVERIN TISCHBACKOFEN MIT KOCHPLATTE KH 2049

[. . . ] Always ensure that the crumb tray is properly fitted under the heating elements when using the appliance. Overheated oil or fat may tend to ignite. Therefore do not overfill the baking tray. Do not leave the appliance unattended while in use. [. . . ] - Before using the hot-plates for the first time, let them heat up for approximately 3 minutes at maximum power, while ensuring sufficient ventilation. This will help to `burn in' the protective coating which safeguards the hot-plates against corrosion. During this process, a slight smell and a little smoke may be emitted. This is normal and will only last for a very short time. Using the oven compartment - Pre-heat the oven compartment for several minutes with the door closed, using both heating elements. When cooking food containing fat or moisture, use the baking tray to stop any dripping into the interior of the appliance. - Close the door and set the temperature control knob to the required level. - For overhead baking or grilling, either the upper or the upper and lower elements may be selected. - The switch settings (upper heat/lower heat) may be changed during the cooking process. - To interrupt the cooking process temporarily , set the 5-position switch to the `' position (small dot symbol). - Always use the door handle to open the hot door after use. When removing the baking tray, use the tray handle provided. - After use, set the 5-position switch to the `' position (small dot symbol) and remove the plug from the wall socket. 5-position switch settings (large dot symbol) ­ both hot-plates enabled (small dot symbol) small hot-plate enabled Upper heating elementand small hotplate enabled Lower heating elementand small hotplate enabled Both upper and lower heating elements and small hot-plate enabled Before using for the first time - Clean the appliance (see General care and cleaning) and remove any packing materials completely. - Before using the appliance for the first time, let the interior heat up for 10 minutes with both heating elements on. A slight smell may be emitted; this is Using the hot-plates - Always place a pot / saucepan on the hotplate and set the 5-position switch to the `' position (large dot symbol) before switching on. - With one or both hot-plates switched on , the indicator lamp is lit. - Ensure that the pot is clean and dry on the outside. Do not use stain covered or soot pots / saucepans. - To prevent damage to the hot-plate, only use pots / saucepans with flat bottoms. Most suitable are pots specifically designed for use on electric plates (see picture I). - Always make sure that the pot / saucepan used is of at least the same diameter as the plate; this minimises the loss of heat and prevents the plate from being damaged as a result of uneven heat distribution. [. . . ] - Replace the glass plate and secure it with the screw. Disposal Do not dispose of old or defective appliances in domestic garbage, but only through public collection points. Guarantee This product is guaranteed against defects in materials and workmanship for a period of two years from the date of purchase. Under this guarantee the manufacturer undertakes to repair or replace any parts found to be defective, providing the product is returned to one of our authorised service centres. [. . . ]