User manual SEVERIN WET & DRY 6 AH 7909

[. . . ] Holder for crevice tool and rubber nozzle Important safety instructions Do not operate the vacuum cleaner without its filter. Before the appliance is used, the main body as well as any attachments should be checked thoroughly for any defects. If the appliance, for instance, has been dropped onto a hard surface, it must no longer be used: even invisible damage may have adverse effects on the operational safety of the appliance. 4 Never use the appliance to pick up hot or smouldering material, nor acid or inflammable liquids. This appliance is not intended for use by any person (including children) with reduced physical, sensory or mental capabilities, or lacking experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. [. . . ] - This appliance can remain on charge indefinitely without damage or danger and is therefore fully charged and ready for use at all times. - Whilst charging, the adapter will become warm. This is perfectly normal and safe and does not indicate a malfunction of any kind. - If the vacuum cleaner is not being used for a long period of time, the capacity of the battery may decrease by a certain amount. However, full capacity will be restored after several charge/discharge cycles. Picking up liquid matter Before picking up liquid matter, ensure that the rubber nozzle is fully inserted in the suction aperture. Crevice tool The crevice tool can be inserted into the suction aperture to clean crevices, corners and other areas difficult to reach. Crevice brush The crevice brush can be fitted to the crevice tool and is suitable for cleaning uneven surfaces such as computer keyboards etc. Operation - Remove the vacuum cleaner from its wall bracket. - If required, fit any of the nozzle attachments to the suction aperture. - Switch on the appliance using the On/Off switch. Always ensure that the dust container is emptied in good time, before the dust or liquid matter collected reaches the level of the inner suction tube. - Should you experience a decrease in vacuuming power during operation, switch off the appliance and recharge. 5 Cleaning General Before cleaning the appliance, remove the vacuum cleaner from the wall bracket. To avoid the risk of electric shock, do not clean the appliance nor the adapter with water and do not immerse them in water. - If necessary, the housing may be wiped with a damp cloth. To empty the dust container Reduced vacuuming power despite a fully charged battery pack indicates that the dust container and filter inlay must be emptied. - Hold the vacuum cleaner with the dust container facing downwards. - Push the release button, open the dust container in a downward and forward direction, remove the filter and empty it. - The filter can be cleaned by slightly tapping it or by using a brush. The filter can be separated from its holder by simply pulling it out of its guide. [. . . ] Guarantee This product is guaranteed against defects in materials and workmanship for a period of two years from the date of purchase. Under this guarantee the manufacturer undertakes to repair or replace any parts found to be defective, providing the product is returned to one of our authorised service centres. This guarantee is only valid if the appliance has been used in accordance with the instructions, and provided that it has not been modified, repaired or interfered with by any unauthorised person, or damaged through misuse. This guarantee naturally does not cover wear and tear, nor breakables such as glass and ceramic items, bulbs etc. [. . . ]