User manual SHARP AH-AP18CE

[. . . ] Please read this manual carefully before operating the product. Do not pull or deform the power supply cord. Pulling and misuse of the power supply cord can result in damage to the unit and cause electrical shock. Be careful not to expose your body directly to the outlet air for a long time. [. . . ] ⷠMake sure there is no curtain or other object between the remote control and the unit. ⷠThe remote control can send signals from up to 7 metres away. Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely affect its operation. If the signal receiver window is exposed to direct sunlight, close a curtain to block the light. ⷠUsing a fluorescent lamp with a quick starter in the same room may interfere with transmission of the signal. ⷠThe unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. ⷠDo not leave the remote control in direct sunlight or near a heater. Also, protect the unit and remote control from moisture and shock which can discolour or damage them. The ionizer inside the air conditioner will release cluster ions, which are collective mass of positive and negative ions, into the room. Cluster ions released into the air will keep your room air clean. Negative cluster ions which also exist in natural environment will be released into the air of your room in an increased rate, and help your physical and mental refreshment. AUTO/DRY MODE The temperature can be changed in 1°C increments within the range of 2°C higher to 2°C lower from the temperature automatically determined by the air conditioner. COOL(HEAT for AY-AP18CE/AY-AP24CE)MODE The temperature can be set within the range of 18 to 32°C. In the DRY mode, the fan speed is preset to AUTO and cannot be changed. To turn off the unit, press the ON/OFF button again. ⷠThe red OPERATION lamp ( unit will turn off. In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature when the unit is turned on. During opration, the FAN SPEED Lamp will light up in 3 levels (2 levels for DRY mode) on the indicator panel of the unit to indicate the fan speed. When fan speed is set to AUTO When fan speed is set to manual Soft speed Low speed High speed The adjusted position will be memorized and will be automatically set to the same position when operated the next time. The adjustment range is narrower the SWING range in order to prevent condensation from dripping. Manual adjustment of the vertical adjustment louvre can cause the unit to malfunction when the remote control is used for the adjustment. ⷠWhen the vertical adjustment louvre is positioned at the lowest position in the COOL or DRY mode for an extended period of time, condensation may result. [. . . ] Button is pressed during normal operation, the unit will turn off. Disconnect 1 Be sure toor turn off thethe power cord from the wall outlet circuit breaker. This is to protect the internal mechanisms. Wait 3 minutes before operating the unit. [. . . ]