User manual SHARP AJ-5030C

[. . . ] This certification means that the equipmentmeets telecommunications network protective, operational and safety requirements as prescribed in the appropriate Terminal Equipment Technical Requirements document(s). Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment. Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas. [. . . ] If a name wasn't stored for an auto-dial number, press 0. This will cause numbers, not names, to appear when you scroll. If no names have been stored that begin with the entered letter, you will scroll from the next name, in alphabetical order, in the list. To display information on transmission jobs currently waiting in memory to be sent, follow the steps below. You can also cancel a job with this procedure. The display will show ACTION STATUS and the number of transmission jobs, and then information on the first job. Press the right arrow key to scroll until the name (or number) appears in the display. Press the left or right arrow key to scroll through the list of jobs. The display will show the 3-digit memory number assigned to the transmission, the time the transmission was set, and status of the job alternating with the name (or number) of the receiving party. To cancel a job, press the START key twice while the job appears in the display. When you have finished viewing the list, press the STOP key repeatedly to return to the date and time display. You can also print out a list of the transmission jobs currently waiting in memory to be sent. To print out the list, press the following sequence of keys: If you wish to use automatic dialing but do not want the document to be transmitted from memory, follow the steps below: If you use the document glass, only one page can be sent. Dial the receiving machine using one of the following methods: · Press the SPEED DIAL key and enter a 2-digit Speed Dial number. Enter a full fax number and then press the START key. (Note: You do not need to press the START key if you dialed with a Rapid Key. You can also send faxes from the document glass. Multiple pages can be sent in a single fax transmission. Note: When using Rapid Key Dialing, make sure no documents are loaded in the auto document feeder. If documents are loaded in both the auto document feeder and on the document glass, the document in the auto document feeder will be faxed. Open the cover of the Color MFP, and place the original face down on the glass with the top edge against the document guide. Make sure the center of the original is aligned with the center mark on the document guide, and then close the cover. [. . . ] Press # or * to scroll through symbols and special characters. Enter the name of the location by pressing number keys. Wait for the reception tone (if a person answers, ask them to press their Start key). MANUAL mode: Answer the call on an extension phone connected to the Color MFP. [. . . ]