User manual SHARP AL-1642CS

[. . . ] MODEL AL-1642CS DIGITAL LASER COPIER DIGITAL MULTIFUNCTIONAL SYSTEM OPERATION MANUAL Page INTRODUCTION SETTING UP THE UNIT LOADING PAPER INSTALLING THE SOFTWARE MAKING COPIES SPECIAL FUNCTIONS MAINTENANCE TROUBLESHOOTING THE UNIT APPENDIX AL-1642CS 4 7 14 19 46 52 57 61 68 FOR YOUR PROTECTION. . . To aid in reporting this unit in case of loss or theft, please record below the model number and serial number located on the back of the unit. We also suggest you record all the information listed and retain for future reference. MODEL NUMBER DATE OF PURCHASE Dealer Address State Service Station Address State Zip City Telephone Zip City Telephone SERIAL NUMBER To obtain service, or to obtain product literature, accessories, or supplies, please call or 1-(630)378-3590 in the USA 905-568-7140 in Canada. For customer assistance, please visit http://www. sharpusa. com/ (for USA) or http://www. sharp. ca/ (for Canada) on the World Wide Web or call 1-(630)378-3590 (for USA). Do not make copies of anything which is prohibited from copying by law. The following items are normally prohibited from copying by national law. [. . . ] 11 Gently close the front cover and then 11 close the side cover. Place the original face down on the document glass or face up in the 47, 48 SPF. 49 50 49 59 ­ Blank copies Copies are too dark or too light. Dust, dirt, smudges appear on copies. Striped copies Clean the transfer charger. If using special papers, feed the paper through the 14 multi-bypass tray. Store paper flat in the wrapper in a ­ dry location. Paper misfeeds Pieces of paper inside unit?Paper guides in the paper Set the guides properly depending on 15, 18 tray not set properly?Too much paper in the Remove excessive paper from the paper tray 1, paper tray 2 or tray. If the unit is Images rub off the Paper damp?not used for long time, remove the copy easily. 71 paper from the paper tray and store it in its wrapper in a dry location. 8 61 STATUS INDICATORS When the following indicators light up or blink on the operation panel or the following alphanumeric codes appear in the display, solve the problem immediately referring to both the table below and the relevant page. Be sure to use only genuine SHARP parts and supplies. Cause and remedy Steadily Replacement of drum cartridge will be needed soon. Drum replacement lit required indicator Blinking Drum cartridge must be replaced. Steadily Replacement of TD cartridge will be needed TD cartridge lit soon. replacement TD cartridge must be replaced. Replace it with a required indicator Blinking new one. Remove the misfed Misfeed indicator Blinking paper referring to the description of "MISFEED REMOVAL". An original misfeed has occurred in the SPF. SPF misfeed Blinking Remove the misfed originals referring to the indicator description of "E: Misfeed in the SPF". Press any key to cancel the preheat mode. Power save indicator is The unit is in the auto power shut-off mode. [. . . ] 49 Setting the copy quantity . . . . . . . . . . . . . . . . . . . 49 Setting the toner save mode . . . . . . . . . . . . . 54 Setting the user program. . . . . . . . . . . . . . . . . . . 55 Setting up the Button Manager. . . . . . . . . . [. . . ]