User manual SHARP AR-168D

[. . . ] MODEL AR-168S AR-168D DIGITAL MULTIFUNCTIONAL SYSTEM OPERATION MANUAL (for general information) Page PREPARATIONS LOADING PAPER MAKING COPIES CONVENIENT COPY FUNCTIONS SET UP THE SOFTWARE PRINTER/SCANNER FUNCTIONS AR-168S 9 14 20 26 36 57 62 USER SETTINGS TROUBLESHOOTING AND MAINTENANCE 69 OPTIONAL EQUIPMENT APPENDIX 90 92 AR-168D For users in the USA FOR YOUR RECORDS . . . To protect against loss theft, record and retain for reference the copier's serial number located on the back of the unit. Model Number Serial Number Date of Purchase Authorized Sharp Copier Service Department Number NOTICE BE SURE TO ASK YOUR AUTHORIZED SHARP DEALER ABOUT THE WARRANTY THAT YOUR SELLING DEALER EXTENDS TO YOU. In order to assure you, the end-user, of warranty protection, Sharp extends a limited warranty to each of its authorized dealers and, in turn, requires each of its authorized dealers to extend its own warranty to you on terms that are no less favorable than those given to the dealer by Sharp. You should be aware, however, that Sharp does not itself extend any warranties, either express or implied, directly to you, the end-user, and no one is authorized to make any representations or warranties on behalf of Sharp. Specifically, SHARP DOES NOT EXTEND TO YOU, THE END-USER, ANY EXPRESS WARRANTY OR ANY IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR USE OR FITNESS FOR ANY PARTICULAR PURPOSE IN CONNECTION WITH THE HARDWARE, SOFTWARE OR FIRMWARE EMBODIED IN, OR USED IN CONJUNCTION WITH THIS PRODUCT. [. . . ] One beep Invalid key beep. . . . . . . . . . . . . . . . . Three beeps Base settings The base settings are preset standard selections for each copy setting. The base settings are as follows: Copy ratio. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100% Light and Dark level . . . . . . . . . . . . . . . . . Center Paper feed location . . . . . . . . . . . . . . . . . Tray 1 (Upper paper tray) AUTO/TEXT/PHOTO . . . . . . . . . . . . . . . . AUTO 68 8 Chapter 8 TROUBLESHOOTING AND MAINTENANCE Problems related to general use of the machine, the copy function, and software setup are explained here. Be sure to check the problem carefully before calling for service, as many problems can be solved by the user. If you are unable to solve the problem, turn off the main switch, unplug the power cord from the outlet, and contact your dealer. Note For problems related to the printer and scanner functions, see the online manual. DISPLAY MESSAGES When the following indicators light up or blink on the operation panel or the following alphanumeric codes appear in the display, solve the problem immediately referring to both the table below and the indicated page. Note Be sure to use only genuine SHARP parts and supplies. Indication Lamp indicator Display BYPASS : ADD PAPER Tray TRAY<*> : ADD location Blinks PAPER indicator CLOSE PAPER TRAY<*> CLEAR PAPER JAM. CLOSE THE SPF/ RSPF COVER. Error indicator Blinks Cause and remedy The indicated paper tray is not attached, is attached incorrectly, or has run out of paper. (The tray is indicated in <*>. ) A paper misfeed has occurred. Remove the misfeed as explained in "MISFEED REMOVAL". Close the cover. Page 15 79 82 83 The SPF/RSPF cover is open. Replace REPLACE THE the toner cartridge with a new TONER cartridge. the machine does not operate. ) When [L1-00] appears, the scan head locking switch is locked. Turn off the power, release the scan head locking switch, and turn the power back on. SYSTEM ERROR [XX - XX] REFER The machine will not function. Turn the TO USER GUIDE power switch off, wait about 10 seconds, and then turn on the switch again. If this does not clear the error, remove the power cord from the outlet, and contact your SHARP service center. 8 86 - 69 TROUBLESHOOTING AND MAINTENANCE Indication Lamp indicator Display TONER CARTRIDGE IS Error Steadily NEAR EMPTY. indicator lit MAINTENANCE REQUIRED CALL FOR SERVICE MEMORY FULL, PRESS START TO RESUME. NO 2-SIDED COPY FROM BYPASS TRAY. NO 2IN1 COPY FROM BYPASS TRAY. INSTALL A TONER CARTRIDGE. Cause and remedy Replacement of toner cartridge will be needed soon. Service by an authorized SHARP service technician is required. Two sided printing or 2 IN 1 copying is selected when the bypass tray is already selected , or the bypass tray is selected when two-sided printing or 2 IN 1 copying is already selected. [. . . ] 82 - Paper feed area. . . . . . . . . . . . . . . . . . . . . . . . . . . . 80 - Transport area. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 81 Toner cartridge, replacing . . . . . . . . . . . . . . . . . 83 Using convenient copy functions 2 IN 1 copying, using - Document glass. . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]