User manual SHARP AR-M256/M316

[. . . ] MODEL AR-M256 AR-M316 DIGITAL MULTIFUNCTIONAL SYSTEM OPERATION MANUAL (for copier) Page · BEFORE USING THE MACHINE · COPY FUNCTIONS · CONVENIENT COPY FUNCTIONS · USER SETTINGS · TROUBLESHOOTING AND MAINTENANCE · PERIPHERAL DEVICES AND SUPPLIES · APPENDIX 8 21 35 52 58 77 81 With the RSPF installed Each instruction also covers the optional units used with these products. Do not make copies of anything which is prohibited from copying by law. The following items are normally prohibited from copying by national law. Other items may be prohibited by local law. Money Checks Stamps Passports Bonds Stocks Bank drafts Driver's licenses In some areas, the "POWER" switch positions are marked "I" and " " on the copier instead of "ON" and "OFF". [. . . ] The memory becomes full while scanning originals. Press the [START] key ( ) to copy only the originals that have been scanned, or press the [CLEAR ALL] key ( ) to cancel the job. Page 57 65 15, 27 18 48 73 73 73 22 54 15 74 71 - 5 59 TROUBLESHOOTING AND MAINTENANCE Message SELECTED PAPER TRAY IS OUT OF SERVICE. CHECK STAPLER POSITION OR STAPLE JAM. Cause and solution Contact your authorised service representative. Staples are jammed in the finisher or the staple case is not attached correctly. If the message still appears after removing the jammed staples, disable the stapler using "DISABLING OF STAPLER" in the key operator programs (See the "Key operator's guide. ), and contact your authorised service representative. It will soon be time for regular maintenance. Contact your authorised service representative. Contact your authorised service representative. Turn off the power and then turn it back on. If this does not clear the message, write down the 2-digit main code and 2-digit sub-code and promptly contact your authorised service representative. The original in the RSPF is longer than the size that was detected. Reinsert the original, make sure that the size indicated in the touch panel is the same as the actual size, and begin copying. You can also select mixed feeding to copy onto paper that matches each original size after all originals have been scanned. Page - 75 (CALL FOR SERVICE SOON. ) (MAINTENANCE REQUIRED. ) CALL FOR SERVICE. CODE: - - PLEASE CHECK THE ORIGINAL SIZE. JOB IS CANCELED. - 60 TROUBLESHOOTING If you experience difficulty using the machine, check the following troubleshooting guide before calling for service. Many problems can be easily resolved by the user. If you are unable to solve the problem using the troubleshooting guide, turn off the power switch, unplug the machine, and contact your authorised service representative. The following problems are related to the general operation of the machine and copying. For problems related to the printer, fax, and network scanner functions, see the corresponding operation manuals. Problems related to machine operation Problem Power switch OFF. Turn the power switch ON. Cause and solution Page 13 The machine is warming up. The machine requires about 23 seconds to warm up after the power switch is turned on. While the machine is warming up, copy settings can be selected but copying is not possible. Wait until "READY TO COPY. " appears. 13 The machine does not operate. Out of paper. Load paper. 17 73 65 Out of toner. Replace the toner cartridge. Misfeed occurs. Remove the misfed paper. The machine is in auto power shut-off mode. [. . . ] All other trademarks are the property of their respective owners. Connectors Caution: This connector is only intended for service purposes. Any connection to this terminal may cause malfunctions of the copy machine. Instruction for service technician: The cable length for the service terminal has to be less than 3 m (10 feet). RSPF connector Finisher connector LUOKAN 1 LASERLAITE KLASS 1 LASERAPPARAT Parallel connector USB connector CLASS 1 LASER PRODUCT LASER KLASSE 1 INFORMATION ON DISPOSAL A. [. . . ]