User manual SHARP AY-X10BE

[. . . ] Please read this manual carefully before operating the product. Do not pull or deform the power supply cord. Pulling and misuse of the power supply cord can result in damage to the unit and cause electrical shock. Be careful not to expose your body directly to the outlet air for a long time. [. . . ] The battery life is approximately one year in normal use. ⷠWhen you replace the batteries, always change both batteries, and make sure they are the same type. ⷠIf the remote control does not operate properly after replacing the batteries, take out the batteries and reinstall them again after 30 seconds. ⷠIf you will not be using the unit for a long time, remove the batteries from the remote control. Point the remote control towards the unit's signal receiver window and press the desired button. The unit generates a beep when it receives the signal. ⷠMake sure there is no curtain or other object between the remote control and the unit. ⷠThe remote control can send signals from up to 7 metres away. Do not allow the signal receiver window to receive strong direct sunlight, since it can adversely affect its operation. If the signal receiver window is exposed to direct sunlight, close a curtain to block the light. ⷠUsing a fluorescent lamp with a quick starter in the same room may interfere with transmission of the signal. The unit can be affected by signals transmitted from the remote control of a television, VCR or other equipment used in the same room. ⷠDo not leave the remote control in direct sunlight or near a heater. Also, protect the unit and remote control from moisture and shock which can discolour or damage them. Example: 5 o'clock in the afternoon 1 To set to the 12-hour mode, press the CLOCK button once in the first step. 3 1 To set to the 24-hour mode, press the CLOCK button twice in the first step. (The heat mode symbol is provided only on models AYX08BE/AY-X10BE/AY-X13BE) The current time cannot be set when the timer is operating. In the AUTO and DRY 1°C higher mode, the indicator 1°C lower bars represent 2°C lower changes in temperature. ⷠIn the COOL (and HEAT for AY-X08BE/AYX10BE/AY-X13BE) mode, the temperature can be set within the range of 18 to 32 °C · (The heat mode symbol is provided only on models AYX08BE/AY-X10BE/AY-X13BE) In the DRY mode, the fan speed is preset to AUTO and cannot be changed. To turn off the unit, press the ON/OFF button again. In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature and outdoor temperature when the unit is turned on. During operation, if the outdoor temperature changes, the temperature settings will automatically slide as shown in the chart. [. . . ] (The heat mode symbol is provided only on models AY-X08BE/AY-X10BE/AY-X13BE) You can use the ON and OFF timers in combination. And resume operation (With the same mode and temperature settings) to bring the room temperature to the desired level by 7:00 a. Off the circuit breaker, if you have one exclusively for the air conditioner. 1 Make sure that the air filters are not dirty. [. . . ]