User manual SHARP AY-XM7CR

[. . . ] Please read this manual carefully before operating the product. Do not pull or deform the power supply cord. Pulling and misuse of the power supply cord can result in damage to the unit and cause electrical shock. Be careful not to expose your body directly to the outlet air for a long time. [. . . ] In such case, change the remote control's mode and send the same mode signal which the other indoor unit(s) is/are operating in. In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature and outdoor temperature when the unit is turned on. The indicator panel will change each time you press the DISPLAY button in the following manner. The room temperature and POWER MONITOR are displayed. When the room temperature or the outdoor temperature is displayed, the POWER MONITOR will light up in 4 levels for COOL and HEAT modes (3 levels for DRY mode), to indicate the operation power. When the air conditioner is operating at maximum power in the COOL and HEAT modes, "POWER" will light and "ECO" will turn off on the indicator panel. The displayed temperatures are rough estimates and may vary from the actual temperatures. ⷠTemperature display ranges Room temperature: 0°C ~ 40°C ( is displayed when less than 0°C and when higher than 40°C) Outdoor temperature: -9°C ~ 45°C ( is displayed when less than -9°C and when higher than 45°C) · Is displayed during the first 120 seconds of operation while the temperatures are being detected. (Temperature detection may more than 120seconds when other unit(s) is/are already being operated. ) · Is displayed for 5 seconds when the unit is not in operation. During operation, if the outdoor temperature changes, the temperature settings will automatically slide as shown in the chart. ⷠMode of the unit operated first will have priority over other unit(s) without reference to the chart. The adjusted position will be memorized and will be automatically set to the same position when operated the next time. The adjustment range is narrower the SWING range in order to prevent condensation from dripping. Manual adjustment of the vertical adjustment louvre can cause the unit to malfunction when the remote control is used for the adjustment. ⷠWhen the vertical adjustment louvre is positioned at the lowest position in the COOL or DRY mode for an extended period of time, condensation may result. Do not adjust the horizontal adjustment louvre extremely to the right or left when operating the air conditioner with fan speed "SOFT" for an extended period of time. In this operation, the air conditioner works at maximum power to makes the room cool or warm so rapidly that you can use it just after you come home. FULL POWER operation will also be cancelled when the operation mode is changed, or when the unit is turned off. You cannot set the temperature and fan speed during the FULL POWER operation. When the ONE-HOUR OFF TIMER is set, the unit will stop operating after one hour. The orange TIMER lamp ( ) on the unit will light up. [. . . ] When one indoor unit is operating in COOL or DRY mode, you can not operate the other unit in HEAT mode. When one indoor unit is operating in HEAT mode, you can not operate the other unit in COOL nor DRY mode. This sound is generated by the friction of the front panel and other components expanding or connecting due to a temperature change. The soft, swishing noise is the sound of the refrigerant flowing inside the unit. [. . . ]