User manual SHARP AY-XP9FR

[. . . ] Attention: If you want to dispose of this equipment, please do not use the ordinary dust bin!Used electrical and electronic equipment must be treated separately and in accordance with legislation that requires proper treatment, recovery and recycling of used electrical and electronic equipment. Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. [. . . ] To turn off the unit, press the ON/OFF button again. In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature and outdoor temperature when the unit is turned on. During operation, if the outdoor temperature changes, the temperature settings will automatically slide as shown in the chart. The indicator panel will change each time you press the DISPLAY button in the following manner. The displayed temperatures are rough estimates and may vary from the actual temperatures. ⷠTemperature display ranges Room temperature: 0°C ~ 40°C ( is displayed when less than 0°C and when higher than 40°C) Outdoor temperature: ­9°C ~ 45°C ( is displayed when less than ­9°C and when higher than 45°C) · Is displayed during the first 60 seconds of operation while the temperatures are being detected. ⷠOnly the room temperature can be displayed for 5 seconds when the unit is not in operation. Room and outdoor temperature will not be displayed even if you press the DISPLAY button. Press the SWING button again when the vertical adjustment louvres are at the desired position. The adjusted position will be memorized and will be automatically set to the same position when operated the next time. The adjustment range is narrower the SWING range in order to prevent condensation from dripping. Manual adjustment of the vertical adjustment louvre can cause the unit to malfunction when the remote control is used for adjustment. ⷠWhen the vertical adjustment louvre is positioned at the lowest position in the COOL or DRY mode for an extended period of time, condensation may result. Do not adjust the horizontal adjustment louvre to the extreme left or right in the COOL mode with the fan speed set to "SOFT ( )" for an extended period of time. Press the PROGRESSIVE AIRFLOW button during cooling or dry operation when you do not want to feel cold air. Vertical adjustment louvres are set obliquely upward to deliver cool air to the ceiling. press the button during heating operation. Vertical adjustment louvres are set downward to deliver the warm air down to the floor and warm you. The PROGRESSIVE AIRFLOW setting is cancelled when you press FULL POWER button while PROGRESSIVE AIRFLOW is set. ⷠIf you want PROGRESSIVE AIRFLOW operation in FULL POWER mode, press PROGRESSIVE AIRFLOW button during FULL POWER operation. In this operation, the air conditioner works at maximum power to makes the room cool or warm so rapidly that you can use it just after you come home. The green FULL POWER lamp ( ) on the unit will light up. [. . . ] The following conditions do not denote equipment malfunctions UNIT DOES NOT OPERATE The unit will not operate if it is turned on immediately after it is turned off. The unit will not operate immediately after the mode is changed. This is to protect the internal mechanisms. Wait 3 minutes before operating the unit. [. . . ]