User manual SHARP AY-XP9LSR

[. . . ] It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collection system for these products. In the European Union Attention: If you want to dispose of this equipment, please do not use the ordinary dust bin!Used electrical and electronic equipment must be treated separately and in accordance with legislation that requires proper treatment, recovery and recycling of used electrical and electronic equipment. [. . . ] ⷠIf the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. Use only the manufacturespecified power cord for replacement. 17 NOTE: Actual units might vary slightly from those shown above. Point the remote control towards the receiver window and press the desired button. The unit generates a beep when it receives the signal. ⷠMake sure nothing, such as curtains, block the signal receiver window. Make sure the (+) and (-) polarities are correctly aligned. The battery life is approximately 1 year in normal use. ⷠWhen replacing the batteries, always change both and use the same type. ⷠIf you will not be using the unit for a long time, remove the batteries from the remote control. Do not expose the receiver window to direct sunlight. This may adversely affect its operation. ⷠUse of certain fluorescent lamp in the same room may interfere with transmission of the signal. ⷠDo not leave the remote control in direct sunlight or near a heater. Protect the remote control from moisture and shock. Use this mode when the remote control is not available. The red OPERATION lamp ( ) will light and the unit will start operating in the AUTO mode. ⷠThe fan speed and temperature setting are set to AUTO. (AUTO/DRY mode) The temperature can be changed up to ±2 °C the automatically set of temperature. AUTO MODE In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature and outdoor temperature when the unit is turned on. During operation, if the outdoor temperature changes, the temperature settings will automatically change. DRY MODE The fan speed is preset to AUTO and cannot be changed. [. . . ] ⷠCondensation may form on the air outlet if the unit operates continuously in the COOL or DRY mode when humidity is over 80 %. This air conditioner has a memory function to store settings when a power failure occurs. After power recovery, the unit will automatically re-start in the same settings which were active before the power failure, except for timer settings. ⷠIf a power failure occurs while the timer is set, the timer setting will be cancelled and will not be retrieved even after the power is restored. [. . . ]