User manual SHARP AY-XP9HR

[. . . ] Attention: If you want to dispose of this equipment, please do not use the ordinary dust bin!Used electrical and electronic equipment must be treated separately and in accordance with legislation that requires proper treatment, recovery and recycling of used electrical and electronic equipment. Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. [. . . ] ⷠClose the windows and doors during cooling and heating operations. The indoor unit still consumes a small amount of power when it is not operating. Use this mode when the remote control is not available. The red OPERATION lamp ( light and the unit will start operating in the AUTO mode. ⷠThe fan speed and temperature setting are set to AUTO. The filters are sealed in a plastic bag to keep their dust collection effect. Do not open the bag until using the filters. (Otherwise the filters life may get shorter. Button is pressed during normal operation, the unit will turn off. The temperature can be changed in 1°C increments within the range of 2°C higher to 2°C lower from the temperature automatically determined by the air conditioner. In the AUTO mode, the temperature setting and mode are automatically selected according to the room temperature and outdoor temperature when the unit is turned on. The temperature can be set within the range of 18 to 32°C. During operation, if the outdoor temperature changes, the temperature settings will automatically slide as shown in the chart. MODE CHANGEOVER During seasons when you need COOLING at daytime and HEATING at night, or if the room temperature should become extremely higher than the temperature setting, due to supplementary heating equipment, the mode will automatically switch between HEAT and COOL mode to keep the comfortable room temperature. In the DRY mode, the fan speed is preset to AUTO and cannot be changed. Press the ) again when 2 the desiredSWING button( louvres are at horizontal adjustment the position. The adjusted position will be memorized and will be automatically set to the same position when operated the next time. ⷠThe sdjustment range is narrower the SWING range in order to prevent condensation from dripping. Manual adjustment of the louvres can cause the unit to malfunction. ⷠWhen the vertical adjustment louvre is positioned at the lowest position in the COOL or DRY mode for an extended period of time, condensation may result. Press the PROGRESSIVE AIRFLOW button during cooling or dry operation when you do not want to feel cold air. Vertical adjustment louvre is set downward to deliver the warm air down to the floor and warm you. [. . . ] ⷠCheck whether any heat-generating appliances are operating in the room. iF THE UNIT FAILS TO RECEIVE THE REMOTE CONTROL SIGNAL · Check whether the remote control batteries have become old and weak. ⷠTry to send the signal again with the remote control pointed properly towards the unit's signal receiver window. ⷠCheck whether the remote control batteries are installed with the polarities properly aligned. [. . . ]