User manual SHARP CD-BK100W

[. . . ] Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product. When the ON/STAND-BY button is set at STAND-BY position, the unit may be brought into operation by the timer mode or remote control. [. . . ] Z The hour will not advance even if minutes advance from "59" to "00". ) The time display will disappear after a few seconds. The "CLOCK" or time will flash at the push of the CLOCK button when the AC power supply is restored after a power failure or unplugging the unit. (AM 0:00 - PM 11:59) Note that this can only be set when the unit is first installed or it has been reset. Press the ON/STAND-BY button to turn the power on. When loading a third disc, press the DISC SKIP button to turn the disc tray, then place the CD in the open position. Z CDs can be placed on any open position on the disc tray. Z Be sure to place 8 cm (3") CD(s) in the middle of the disc positions. To select the CD you want to listen to first, press one of tons on the remote control. , , To locate the beginning of a track To move to the beginning of the next track: Z You can skip to any track by pressing the button repeatedly until the desired track number appears. Z Playback will begin from track 1 on the disc you have selected to play. After that disc finishes playing, the next disc will automatically start playback. Z When the last track on the third disc has finished playing, the CD player will stop automatically. Z When there is no CD in one of the disc 1 - 3 positions, that position will be skipped and the next CD will be played. Z You can skip to any track by pressing the button repeatedly until the desired track number appears. You can locate the beginning of a track on a single disc only. Press and hold down the button during playback. Press and hold down the button during playback. Press the ON/STAND-BY button to enter the power stand-by mode. Z z z z z Do not place two CDs in one disc tray. If the power fails whilst the tray is open, wait until the power is restored. If the disc tray is stopped forcibly, "ERR 0203" will appear in the display and the unit will not function. [. . . ] Once the sleep time is set, it will remain unchanged until a new time is entered. When the tape reaches its end, the unit will enter the stand-by mode. Once the time is set, the setting will be retained until a new time is entered. When this product is subjected to strong external interference (mechanical shock, excessive static electricity, abnormal supply voltage due to lightning, etc. [. . . ]