User manual SHARP CD-DP900H

[. . . ] Mini Komponenten System CD-DP900H besteht aus CD-DP900H (Hauptgert), CP-DP900H (FrontLautsprecher), GBOXS0091AWM1 (Center-Lautsprecher) und GBOXS0092AWM1 (Surround-Lautsprecher). Mini-chane CD-DP900H compose de CD-DP900H (appareil principal), CP-DP900H (enceintes avant), GBOXS0091AWM1 (enceinte centrale) et GBOXS0092AWM1 (enceintes surround). Sistema mini CD-DP900H que consta de CD-DP900H (aparato principal), CP-DP900H (altavoces delanteros), GBOXS0091AWM1 (altavoz central), y GBOXS0092AWM1 (altavoces de sonido perimtrico). MINI KOMPONENTEN SYSTEM MINI-CHANE SISTEMA MINI MINI KOMPONENT SYSTEM MINI SISTEMI MINI SYSTEEM MINI SISTEMA DE COMPONENTES MINI COMPONENT SYSTEM MODELL MODLE MODELO MODELL MODELLO MODEL MODELO MODEL CD-DP900H mini komponent system bestende av CD-DP900H (huvudenheten), CP-DP900H (frmre hgtalarna), GBOXS0091AWM1 (centrum hgtalaren), GBOXS0092AWM1 (surroundrum hgtalarna). Mini sistemi CD-DP900H composto da CD-DP900H (apparecchio principale), CP-DP900H (diffusori frontali), GBOXS0091AWM1 (diffusore centrale) e GBOXS0092AWM1 (diffusori surround). [. . . ] Hold it down to change the time in 5-minute intervals. The hour will not advance even if minutes advance from "59" to "00". The clock begins counting from "0" seconds. (Seconds are not displayed. ) The time display will disappear after a few seconds. - Setting the clock - 1 2 Press the ON/STAND-BY button to turn the power on. Basic Operation 1 2 3 4 5 6 7 8 To confirm the time display: 3 Press the TUNING/TIME ( or ) button to select 24-hour or 12hour display and then press the MEMORY/SET button. Press the CLOCK button. The time display will appear for about 5 seconds. Note: The "CLOCK" or time will flash at the push of the CLOCK button when the AC power supply is restored after a power failure or unplugging the unit. "0:00" "AM 12:00" "AM 0:00" The 24-hour display will appear. (0:00 - 23:59) The 12-hour display will appear. (AM 12:00 - PM 11:59) The 12-hour display will appear. To readjust the clock: Perform "Setting the clock" from step 1. If the time display is flashing, step 3 (for selecting the 24-hour or 12-hour display) will be skipped. To change the 24-hour or 12-hour display: 1 2 Clear all the programmed contents. [Refer to "Clearing all the memory (reset)" on page 30 for details. ] Perform "Setting the clock" from step 1. (AM 0:00 - PM 11:59) Note that this can only be set when the unit is first installed or it has been reset. [Refer to "Clearing all the memory (reset)" on page 30 for details. ] E-12 02/1/11 CD-DP900H(H)_1. fm CD-DP900H Listening to a CD (CDs) This system can also play audio CD-R and CD-RW discs, but cannot record. Some audio CD-R and CD-RW discs may not be playable due to the state of disc or the device that was used for recording. ENGLISH 5 Press the OPEN/CLOSE button to close the disc tray. Total number of tracks on the CD whose number is flashing Total playing time of the CD whose number is flashing 6 7 - Listening to a CD (CDs) - To select the CD you want to listen to first, press the DISC SKIP button. Press the /( ) button to start playback. CD Playback 1 2 3 4 Press the ON/STAND-BY button to turn the power on. Press the OPEN/CLOSE button to open the disc tray. Playback will begin from track 1 on the disc you have selected to play. After that disc finishes playing, the next disc will automatically start playback. When the last track on the third disc has finished playing, the CD player will stop automatically. When there is no CD in one of the disc 1 - 3 positions, that position will be skipped and the next CD will be played. Place the CD(s) on the disc tray, label side up. When loading a third disc, press the DISC SKIP button to turn the disc tray, then place the CD in the open position. To interrupt playback: Press the CD button on the remote control. To resume playback from the same point, press the button. CDs can be placed on any open position on the disc tray. Be sure to place 8 cm (3") CD(s) in the middle of the disc positions. To stop playback: Press the (CD ) button. To remove the CDs: 12 cm (5") 8 cm (3") Whilst in the stop mode, press the OPEN/CLOSE button. Then, press the DISC SKIP button to rotate the disc tray and remove the remaining disc. After use: Press the ON/STAND-BY button to enter the power stand-by mode. E-13 Sound control (See page 11. ) 02/1/9 CD-DP900H(H)_2. fm CD-DP900H ENGLISH To locate the beginning of a track To move to the beginning of the next track: Press the / button for less than 0. 5 seconds during playback. You can skip to any track by pressing the / button repeatedly until the desired track number appears. Starting playback with a desired track You can play a disc starting with the desired track. 1 2 Whilst in the stop mode, press the DISC SKIP button to select the desired disc. [. . . ] If a power failure occurs during playback, the heads remain engaged with the tape. When this product is subjected to strong external interference (mechanical shock, excessive static electricity, abnormal supply voltage due to lightning, etc. ) or if it is operated incorrectly, it may malfunction. If such a problem occurs, do the following: 1 Set the unit to the stand-by mode and turn the power on again. 2 If the unit is not restored in the previous operation, unplug and plug in the unit, and then turn the power on. ENGLISH Note: If neither operation above restores the unit, clear all the memory by resetting it. Clearing all the memory (reset) 1 2 Remote control Symptom The remote control does not operate. Possible cause Is the AC power lead of the unit plugged in? [. . . ]