User manual SHARP DX-450HM

[. . . ] 3" (8cm) CD-SINGLES This unit is not designed to play 3" (8cm) CD-Single discs. Inserting a 3" disc into the magazine, either with or without a 3" disc adaptor, can damage the changer and the disc. Such damage will not be covered by the Warranty on this product. 2 HANDLING COMPACT DISCS Dirt, dust, scratches and warpage cause sound skips during playback and a deterioration of sound quality. Fingerprints and dust should be carefully wiped off the disc's signal surface (glossy side) with a soft cloth. [. . . ] Wipe in a straight motion from the inside to the outside of the disc. Small dust particles or light stains will have absolutely no effect on reproduction quality. Never use chemicals such as record sprays, antistatic sprays or fluids, benzine or thinner to clean compact discs. Such chemicals could irreparably damage the disc's plastic surface. Discs should be put back in their cases after use to avoid serious scratches that could cause the sound to skip. Do not expose discs to direct sunlight, high humidity, or high temperatures for extended periods of time. Long exposure to high temperatures can warp the disc. Do not stick paper, labels, or tape on the disc surface. Do not write with any type of pen, pencil, or marker on the disc surface. To minimize fingerprints and smudges on the signal surface, always try to hold the discs by their outer edge and center hole. 3 USE OF THE CD MAGAZINE LOADING DISCS INTO THE MAGAZINE This CD Changer uses a specially-designed magazine to hold up to 6 compact discs. Insert discs into the magazine with the label side up as shown in Figure 1. SETTING UP FOR OPERATION Following the instructions in the "USE OF THE CD MAGAZINE" section of this manual, load the desired number (up to 6) of 5" (12cm) compact discs into the CD magazine and insert the magazine into the changer. DO NOT USE 3" (8cm) CD SINGLES, EITHER WITH OR WITHOUT AN ADAPTER, IN THIS CHANGER. DAMAGE TO THE CHANGER AND/OR DISC MAY OCCUR AND SUCH DAMAGE WILL NOT BE COVERED BY THE WARRANTY ON THIS PRODUCT. Turn on the car stereo and select CDC operation to access the changer. The LCD panel on the associated radio will indicate the start of disc #1 play. Adjust the volume, balance and tone to your taste by using the controls on the car stereo. When the last track on the disc has been played, the unit will automatically advance to and begin play of the next disc. When the last track on disc #6 has been played, the unit will automatically return to disc #1 and begin play again. SPECIFICATIONS Frequency Response: 20 - 20, 000 Hz. ±1 dB Distortion: Dynamic Range: Channel Separation: Wow & Flutter: 0. 03% @ 1 kHz. below measurable limits * Due to continuing improvement, Audiovox reserves the right to change features and design without notice. Dimensions: Changer: 11. 18"W x 2. 91"H x 7. 42"D 284mm x 74 mm x 188. 5mm Operating Voltage: 12 volts DC, negative ground Signal-to-Noise Ratio: 85 dB 6 TROUBLESHOOTING An error made in operation or during installation of this product may be mistaken for a system malfunction. Please perform the checks described below before contacting your dealer or service facility. TROUBLESHOOTING GUIDE SYMPTOM Disc will not play/erratic disc operation PROBABLE CAUSE Moisture on optics Improper connections Radio on wrong station Disc inserted wrong REMEDY W 1-2 hours with changer in dry ait location and then try again Check all wire connections and routing Check selected radio station against modulator frequency setting Re-insert disc properly Press RESET button and check all fuses Seek assistance from authorized dealer Check connections Check fuses Reset unit Seek assistance from authorized dealer Reset unit Seek assistance from authorized dealer Headset/Controller does not respond Improper connection Blown fuse Erratic operation Internal malfunction 7 12 MONTH LIMITED WARRANTY SHARP CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor. [. . . ] To obtain repair or replacement within the terms of this Warranty, the product is to be delivered with proof of warranty coverage (e. g. dated bill of sale), specification of defect(s), transportation prepaid, to the warranty center at the address shown below. This Warranty does not extend to the elimination of car static or motor noise, to correction of antenna problems, to costs incurred for installation, removal, or reinstallation of the product, or damage to tapes, compact discs, speakers, accessories, or vehicle electrical systems. This Warranty does not apply to any product or part thereof which, in the opinion of the Company, has suffered or been damaged through alteration, improper installation, mishandling, misuse, neglect, accident, or by removal or defacement of the factory serial number/bar code label(s). [. . . ]